Designed specifically to be used with late model Mercury 4000 series controls. Engineered to significantly reduce or eliminate cable "Wig-Wag", this design results in a significantly improved feel with less shifting effort. Improves the feel of the Mercury 4000 Series Controls. Nickel plated brass swivel tube. WHILE QUANTITIES LAST.

OMC 479 type cable (1979 & later). Complete drop-in replacement cable for OMC O/B and I/O's. Stainless steel and brass fittings. 6" minimum bend radius. WHILE QUANTITIES LAST.

Louvered Door & Frame Cutout: 14" x 19" Left Hand Opening

3 Blade stainless interchangeable hub propeller for 40-140 horsepower engines with thru hub exhaust, 4-1/4" gear case. Category D+ prop. Requires RBX™ hub kit for installation.

3 Blade stainless interchangeable hub propeller for 40-140 horsepower engines with thru hub exhaust, 4-1/4" gear case. Category D+ prop. Requires RBX™ hub kit for installation.

3 Blade stainless propeller for Mercruiser Bravo II stern drive engines with 19 tooth spline and thru hub exhaust.

3 and 4 Blade stainless propeller for Volvo Penta DP280, DP290. Front propeller is 27 tooth spline. Rear Propeller is 19 tooth spline.

3 Blade aluminum propeller for 35-50 horsepower engines with 13 tooth spline and thru hub exhaust. 3-1/4" Gear Case.

Heavy duty black molded plastic base. Use with SFE, AGC or MDL fuses up to 20 amps. Brass fuse clips and 8-32 terminal screws. Common bus bar connects the hot side of fuses for power feed. Bus bar has 8-32 stud terminals for main power / ground main connections. Rated 20 amps per circuit, 120 amps total for block.

Gasoline and solvent-resistant primer bulbs meet or exceed EPA/CARB Fuel Permeation Regulations. Stainless steel clamps and dual internal check valves to ensure rapid prime while preventing fuel flow back.

3 Blade stainless propeller for Yamaha 50-130 and Nissan/Tohatsu 60-140 horsepower engines. Both with 15 tooth spline, thru hub exhaust and 4-1/4" Gear Case.

High quality brass hose barb for fuel line.

High quality brass hose barb for fuel line.

High performance permanent magnet gear reduction starter. 2 long bolt staggered pattern, CW rotation. use with late model 3.0L engines with 14" flywheel. Uses SW450 replacement solenoid and DV450 replacement drive assembly with 11 tooth drive gear. Will replace 9-tooth OEM version. NOTE: Does not include mounting bolt kit (required if replacing 10MT style starters). Order MBK450 Mounting Kit separately.

Specifically designed to be used on smaller commercial fishing vessels. Features stainless steel shaft, heavy duty shaft seal and wiper. Shaft and seal help protect the pump from the abrasive effects of sediment that is brought on board by the operator handling traps or pots. 1000 PSI relief valve setting. Adjustable stainless steel ORB O-ring fittings simplify installation and allow simple reorientation of fittings after installation. Anodized rear cover, anodized black port plugs.