Yanmar X0529530-01 Lip Seal
The Yanmar X0529530-01 is the genuine lip seal for Yanmar marine diesel sea water pumps that use this part. It runs against the turning pump shaft and keeps raw water on the water side of the pump, away from the bearing behind it.
Inspect the shaft whenever the seal is out. A ridge or a polished groove where the old lip ran will cut a new seal quickly, so a marked shaft means the shaft should be dealt with too rather than sealing against it and hoping. Fit the new seal squarely, lip toward the water, and never tap directly on the lip.
Key Features
- Genuine Yanmar replacement lip seal
- Fits Yanmar marine diesel sea water pumps that use this part
- One per pump
- Keeps raw water away from the pump bearing
- Dynamic seal running directly on the pump shaft
- Best replaced as a set with the other pump seals
Applications
- Yanmar marine diesel sea water pumps that use this part
- Raw water pump rebuilds
- Curing a weep or salt crust at the pump drain
- Service before salt water reaches the bearing
- Repairing a pump after a bearing failure
- Spring commissioning and layup service
Specifications
- Brand: Yanmar
- Manufacturer: Yanmar Marine
- Manufacturer Part Number: X0529530-01
- Part Type: Lip Seal
- Fits: Yanmar marine diesel sea water pumps that use this part
- Quantity Used: One per pump
- Condition: New
Frequently Asked Questions
Q: There is salt crusting under the pump. Is the seal gone?
That is the classic sign. Water is passing the seal and evaporating on the outside. Deal with it early, because the next thing it reaches is the bearing.
Q: Can I fit a new seal to a worn shaft?
Not with much hope. A groove where the old lip ran gives the new one nothing flat to follow, and it will weep again quickly.
Q: Which way round does the seal go?
Lip toward the water it is sealing, so pressure pushes the lip against the shaft rather than away from it. Note the orientation of the old one before it comes out.
Q: Why are there two seals in the pump?
One keeps water in, the other keeps bearing lubrication in, and the space between them vents through the drain so a failure shows outside instead of contaminating the bearing.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct lip seal.
CLRMarine
