Yanmar 24423-203508 Bearing Seal

Basic Info

Warranty Info

Literature

Rebate Info

Video

Shipping Dimensions
3" x 3" x 5" (0.1 lbs)

Brand
Yanmar

Manufacturer
Yanmar Marine

Manufacturer Part Number
24423-203508

Country of Origin
Japan

Special Order
No

Exportable
Yes

HTS Code
8413.91.9096

Truck Freight
No

Quantity In Stock
2

On Order
0

Your Price
$6.13

Qty

Yanmar 24423-203508 Bearing Seal

The Yanmar 24423-203508 is the factory bearing seal used in Yanmar marine diesel sea water pumps that use this part. It is a dynamic seal - the shaft slides through it continuously while the engine runs - which is why it wears out on a schedule while the static seals around it last for years.

These pumps are usually fitted with more than one seal separating the water side from the bearing side. Replace them as a set when the pump is apart - they have the same age and the same hours, and reaching them is most of the work.

Key Features

Genuine Yanmar replacement bearing seal
Fits Yanmar marine diesel sea water pumps that use this part
One per pump
Keeps raw water away from the pump bearing
Dynamic seal running directly on the pump shaft
Best replaced as a set with the other pump seals

Applications

Yanmar marine diesel sea water pumps that use this part
Raw water pump rebuilds
Curing a weep or salt crust at the pump drain
Service before salt water reaches the bearing
Repairing a pump after a bearing failure
Spring commissioning and layup service

Specifications

Brand: Yanmar
Manufacturer: Yanmar Marine
Manufacturer Part Number: 24423-203508
Part Type: Bearing Seal
Fits: Yanmar marine diesel sea water pumps that use this part
Quantity Used: One per pump
Condition: New

Frequently Asked Questions

Q: How do I fit it without damage?
Support it squarely and press on the outer face, never on the lip. Most seals that leak straight after a rebuild were damaged or cocked on the way in.

Q: How often should seals be replaced?
Whenever the pump is apart far enough to reach them, and immediately if there is any sign of water tracking past them.

Q: There is salt crusting under the pump. Is the seal gone?
That is the classic sign. Water is passing the seal and evaporating on the outside. Deal with it early, because the next thing it reaches is the bearing.

Q: Can I fit a new seal to a worn shaft?
Not with much hope. A groove where the old lip ran gives the new one nothing flat to follow, and it will weep again quickly.

Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct bearing seal.

k 1

CLR Marine is proud to serve the boating community by providing top-quality marine supplies for safety, performance, and adventure on the water.