Yanmar 145410-46110 Gasket

Basic Info

Warranty Info

Literature

Rebate Info

Video

Shipping Dimensions
4" x 4" x 6" (0.1 lbs)

Brand
Yanmar

Manufacturer
Yanmar Marine

Manufacturer Part Number
145410-46110

Country of Origin
Japan

Special Order
No

Exportable
Yes

HTS Code
8413.91.9096

Truck Freight
No

Quantity In Stock
1

On Order
0

Your Price
$6.32

Qty

Yanmar 145410-46110 Gasket

The Yanmar 145410-46110 is the factory gasket used in Yanmar marine diesel sea water pumps that use this part. It costs very little and it is the part whose failure is hardest to diagnose, which makes it one worth renewing rather than reusing.

Fit it the right way round. The holes match the port pattern of that joint and are often not symmetrical, so a gasket fitted reversed can block a passage entirely and leave you with a pump that turns and delivers nothing.

Key Features

Genuine Yanmar replacement gasket
Fits Yanmar marine diesel sea water pumps that use this part
One per pump
Cut to the factory port pattern so passages line up
Restores a positive seal between machined faces
Inexpensive part that prevents joint corrosion

Applications

Yanmar marine diesel sea water pumps that use this part
Raw water pump rebuilds and impeller changes
Reassembly after any pump joint is opened
Curing a weep at a mounting or port joint
Replacing a pump on the engine
Spring commissioning and layup service

Specifications

Brand: Yanmar
Manufacturer: Yanmar Marine
Manufacturer Part Number: 145410-46110
Part Type: Gasket
Fits: Yanmar marine diesel sea water pumps that use this part
Quantity Used: One per pump
Condition: New

Frequently Asked Questions

Q: Why is a small weep worth chasing?
Because sea water trapped between two faces pits them, and a pitted joint will not seal properly again even with a new gasket.

Q: Is a mounting gasket different from a port gasket?
They seal different joints and are cut differently. Both should be renewed whenever their joint is disturbed.

Q: Can I reuse a gasket that came off in one piece?
It has taken a set in the joint and lost the compression it needs to seal. On a salt water joint that is how corrosion starts between the faces.

Q: Does it matter which way round it goes?
Yes. The holes match the port pattern and are often not symmetrical, so a gasket fitted reversed can block a water passage.

Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct gasket.

k 1

CLR Marine is proud to serve the boating community by providing top-quality marine supplies for safety, performance, and adventure on the water.