Yanmar 127610-42070 Seal Case for 4LH and 4LHA
The Yanmar 127610-42070 is the genuine seal case for 4LH, 4LHA and 6BY Series engines. It closes one end of the pump and, just as importantly, forms the flat face the impeller vanes seal against on that side of the pumping chamber.
In salt water they also corrode from the inside out, pitting the face the impeller runs against. Lay the cover on a known flat surface and look for daylight under the edges, then look across the inner face for pitting and scoring. Either one is enough to cost flow.
Key Features
- Genuine Yanmar replacement seal case
- Fits 4LH, 4LHA and 6BY Series engines
- One per pump
- Restores a flat sealing face for the impeller
- Replaces a distorted, pitted or corroded cover
- Renew the cover seal at the same time
Applications
- 4LH, 4LHA and 6BY Series engines
- Raw water pump rebuilds and impeller changes
- Curing air being drawn in at the cover joint
- Replacing a cover bowed by overtightening
- Repairing corrosion damage on a pump that has seen years of salt water
- Spring commissioning and layup service
Specifications
- Brand: Yanmar
- Manufacturer: Yanmar Marine
- Manufacturer Part Number: 127610-42070
- Part Type: Seal Case
- Fits: 4LH, 4LHA and 6BY Series engines
- Quantity Used: One per pump
- Condition: New
Frequently Asked Questions
Q: Should the seal be replaced with the cover?
Yes. It has been disturbed and it takes a set in the joint, and a new cover on an old seal is a leak waiting to happen.
Q: Can a pitted cover face be cleaned up?
Light polishing is reasonable if it leaves the face flat. Anything that takes the face out of flat does more harm than the pitting did.
Q: Does the cover affect how much water the pump moves?
Directly. It is one of the two faces the impeller vanes seal against, so a pitted or bowed cover lets water slip back inside the pump instead of leaving the discharge.
Q: How do I tell if the cover is distorted?
Lay it on something known to be flat and look for daylight under the edges, particularly between the screw holes. A bowed cover will not seal and will not present a flat face to the impeller.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct seal case.
CLRMarine
