Yanmar 105582-42110 Seal
The Yanmar 105582-42110 is the genuine replacement seal for Yanmar marine diesel sea water pumps that use this part. It is a small part that decides whether the pump has a long life or a short one.
This is the seal that decides whether the pump survives. Once the lip hardens or the shaft wears a groove under it, salt water finds its way along the shaft to the bearing, and a bearing that has taken salt water fails soon afterwards. The warning is a weep or a salt crust at the pump drain, usually visible long before anything sounds wrong.
Key Features
- Genuine Yanmar replacement seal
- Fits Yanmar marine diesel sea water pumps that use this part
- One per pump
- Keeps raw water away from the pump bearing
- Dynamic seal running directly on the pump shaft
- Best replaced as a set with the other pump seals
Applications
- Yanmar marine diesel sea water pumps that use this part
- Raw water pump rebuilds
- Curing a weep or salt crust at the pump drain
- Service before salt water reaches the bearing
- Repairing a pump after a bearing failure
- Spring commissioning and layup service
Specifications
- Brand: Yanmar
- Manufacturer: Yanmar Marine
- Manufacturer Part Number: 105582-42110
- Part Type: Seal
- Fits: Yanmar marine diesel sea water pumps that use this part
- Quantity Used: One per pump
- Condition: New
Frequently Asked Questions
Q: Which way round does the seal go?
Lip toward the water it is sealing, so pressure pushes the lip against the shaft rather than away from it. Note the orientation of the old one before it comes out.
Q: Why are there two seals in the pump?
One keeps water in, the other keeps bearing lubrication in, and the space between them vents through the drain so a failure shows outside instead of contaminating the bearing.
Q: How do I fit it without damage?
Support it squarely and press on the outer face, never on the lip. Most seals that leak straight after a rebuild were damaged or cocked on the way in.
Q: How often should seals be replaced?
Whenever the pump is apart far enough to reach them, and immediately if there is any sign of water tracking past them.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct seal.
CLRMarine
