Yamada 770736 PTFE Check Ball for NDP-20
The Yamada 770736 is a genuine Yamada check ball, PTFE, used in NDP-20 series air-operated double diaphragm (AODD) pumps. It seats against the valve seat on every stroke to force fluid to flow in one direction only. Together the two check balls and their seats are what let a reciprocating diaphragm pump move liquid without a separate mechanical valve.
Genuine Yamada replacement parts are machined and molded to the original factory tolerances, so fit, alignment and seal engagement match the component being replaced. Two per pump (one per chamber). Always compare the exact part number against your pump's nameplate before ordering, since Yamada varies internal components by both pump size and body material / elastomer combination.
Key Features
- Genuine Yamada replacement check ball
- Material: PTFE
- Fits NDP-20 series AODD pumps
- Two per pump (one per chamber)
- Molded or machined to factory tolerances for correct fit and seal engagement
Applications
- NDP-20 series AODD pump service and rebuilds
- Scheduled preventive maintenance
- Restoring lost flow, leaks, or erratic cycling
- Marine, industrial, chemical and wash-down service
Specifications
- Brand: Yamada
- Manufacturer: Yamada America
- Manufacturer Part Number: 770736
- Part Type: Check Ball
- Material: PTFE
- Fits: NDP-20 Series
- Condition: New
Frequently Asked Questions
Q: What is the earliest sign this part is wearing out?
Reduced flow, slower cycling, or - for diaphragms and check valve components specifically - fluid appearing at the air exhaust muffler, which signals a breach between the wet side and the air side.
Q: What causes this kind of wear part to fail?
Flex fatigue from normal cycling, chemical attack from the pumped fluid, or heat and hardening over time. Whichever it is, the fix is the same: replace it, and note which failure mode it was so the replacement material can be matched to the service.
Q: How do I know which elastomer is right for my fluid?
Match it to what is already on the pump nameplate or the failed part you are replacing, and check chemical compatibility against the fluid being pumped. Buna-N suits oils and fuels, EPDM suits water and many chemicals, Viton and PTFE suit aggressive or high-temperature service, and Santoprene and Hytrel give long flex life on general duty.
Q: Can I run the pump a little longer before replacing a worn part?
You can, but a part that has started to degrade wears the components around it faster, so a delayed replacement often turns a small parts order into a larger rebuild.
Not sure this is the right part? Send us a picture of your Pump Plate to https://www.clrmarine.com/Contact-Us and the CLR Marine team will confirm the correct check ball.
CLRMarine
