Sta-Rite SNC-L Complete Shallow Well Jet Pump, 1/2 HP
The Sta-Rite SNC-L is a complete shallow well jet pump, part of the SN Series, rated at 1/2 HP. It ships as a ready-to-plumb unit with its motor already mounted, so it drops in as a direct replacement for a worn-out or failed pump of the same model rather than a rebuild project.
A pump in this class is typically replaced rather than rebuilt once the motor windings fail or the pump end has worn past the point where a seal kit would restore performance. built to the same ratings Sta-Rite lists for the SNC-L model.
Key Features
- Complete, factory-assembled shallow well jet pump with motor already mounted
- 1/2 HP motor, 115/230V, single phase
- Cast iron construction for durability under continuous duty
- Rated to 10 GPM max at up to 160 ft max head
- 1-1/4 in NPT suction, 1 in NPT discharge
- Direct replacement for the Sta-Rite SNC-L (SN Series)
Applications
- Shallow or deep well residential water supply, depending on the ejector fitted
- Replacing a Sta-Rite pump that has failed at the motor or pump end rather than a single wear part
- Marine dockside, well house, and utility pump room installations
- Any application already specified for the Sta-Rite SNC-L
Specifications
- Brand: Sta-Rite
- Model: SNC-L
- Part Type: Complete Pump (shallow well jet pump)
- Series: SN Series
- Motor: 1/2 HP, 115/230V, single phase
- Flow: 10 GPM max
- Max Head: 160 ft max head
- Shut-Off Pressure: 56 PSI shut-off pressure
- Body Material: Cast iron
- Connections: 1-1/4 in NPT suction, 1 in NPT discharge
- Condition: New
Frequently Asked Questions
Q: Does this pump include the motor?
Yes. This is the complete pump as Sta-Rite builds it, with the motor already mounted and matched to the pump end; no separate motor purchase is needed.
Q: Will this fit if my old pump has a different model number?
Only if the model numbers match exactly. Sta-Rite uses closely related model codes across different horsepower and voltage points in the same series, so confirm the full model number on the old pump nameplate before ordering.
Q: Can I rebuild my existing pump instead of replacing the whole unit?
If only the seal, gaskets, or impeller have failed, a seal or overhaul kit is usually the cheaper fix. A complete pump like this one makes sense once the motor or pump body itself has failed.
Q: What voltage does this pump run on?
115/230V, single phase. Confirm your electrical supply matches before wiring it in.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct pump.
CLRMarine
