Sta-Rite PWP-01 Complete Shallow Well Jet Pump, 3/4 HP
This is the complete Sta-Rite PWP-01 built as a shallow well jet pump at 3/4 HP. Ordering the complete pump rather than individual parts makes sense once a motor has burned out, a casing has cracked, or enough wear parts have failed that a rebuild would cost more than a fresh unit.
Because this is a complete pump rather than a single part, installation is mostly a matter of matching the plumbing connections and electrical supply to the old unit. Check the voltage and horsepower on the old pump nameplate against this listing before ordering to avoid a mismatch.
Key Features
- Complete, factory-assembled shallow well jet pump with motor already mounted
- 3/4 HP motor
- Direct replacement for the Sta-Rite PWP-01
Applications
- Shallow or deep well residential water supply, depending on the ejector fitted
- Replacing a Sta-Rite pump that has failed at the motor or pump end rather than a single wear part
- Marine dockside, well house, and utility pump room installations
- Any application already specified for the Sta-Rite PWP-01
Specifications
- Brand: Sta-Rite
- Model: PWP-01
- Part Type: Complete Pump (shallow well jet pump)
- Motor: 3/4 HP
- Condition: New
Frequently Asked Questions
Q: Is this pump self-priming?
Sta-Rite jet and centrifugal pumps in this class are self-priming once the pump body and suction line are properly primed with water at startup; follow the priming instructions in the pump manual.
Q: Where should this pump be installed?
In a dry, accessible location such as a well house, basement, or utility room, close to the water source it is drawing from.
Q: Does this pump include the motor?
Yes. This is the complete pump as Sta-Rite builds it, with the motor already mounted and matched to the pump end; no separate motor purchase is needed.
Q: Will this fit if my old pump has a different model number?
Only if the model numbers match exactly. Sta-Rite uses closely related model codes across different horsepower and voltage points in the same series, so confirm the full model number on the old pump nameplate before ordering.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct pump.
CLRMarine
