Sta-Rite PND-10 Complete Shallow Well Jet Pump, 3/4 HP
This is the complete Sta-Rite PND-10, a PN Series unit built as a shallow well jet pump at 3/4 HP. Ordering the complete pump rather than individual parts makes sense once a motor has burned out, a casing has cracked, or enough wear parts have failed that a rebuild would cost more than a fresh unit.
The fiberglass-reinforced thermoplastic construction is built for continuous residential and light-commercial duty, and the specs below reflect the manufacturer nameplate rating rather than a generic estimate. Confirm horsepower, voltage, and port sizes against the pump being replaced, since Sta-Rite reuses similar model families across several different performance points.
Key Features
- Complete, factory-assembled shallow well jet pump with motor already mounted
- 3/4 HP motor, 115/230V, single phase
- Fiberglass-reinforced thermoplastic construction for durability under continuous duty
- Rated to 10 GPM max at up to 185 ft max head
- 1-1/4 in NPT suction, 1 in NPT discharge
- Direct replacement for the Sta-Rite PND-10 (PN Series)
Applications
- Shallow or deep well residential water supply, depending on the ejector fitted
- Replacing a Sta-Rite pump that has failed at the motor or pump end rather than a single wear part
- Marine dockside, well house, and utility pump room installations
- Any application already specified for the Sta-Rite PND-10
Specifications
- Brand: Sta-Rite
- Model: PND-10
- Part Type: Complete Pump (shallow well jet pump)
- Series: PN Series
- Motor: 3/4 HP, 115/230V, single phase
- Flow: 10 GPM max
- Max Head: 185 ft max head
- Shut-Off Pressure: 78 PSI shut-off pressure
- Body Material: Fiberglass-reinforced thermoplastic
- Connections: 1-1/4 in NPT suction, 1 in NPT discharge
- Condition: New
Frequently Asked Questions
Q: Will this fit if my old pump has a different model number?
Only if the model numbers match exactly. Sta-Rite uses closely related model codes across different horsepower and voltage points in the same series, so confirm the full model number on the old pump nameplate before ordering.
Q: Can I rebuild my existing pump instead of replacing the whole unit?
If only the seal, gaskets, or impeller have failed, a seal or overhaul kit is usually the cheaper fix. A complete pump like this one makes sense once the motor or pump body itself has failed.
Q: What voltage does this pump run on?
115/230V, single phase. Confirm your electrical supply matches before wiring it in.
Q: Is this pump self-priming?
Sta-Rite jet and centrifugal pumps in this class are self-priming once the pump body and suction line are properly primed with water at startup; follow the priming instructions in the pump manual.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct pump.
CLRMarine
