Sta-Rite JHD-62HL Complete High Head Centrifugal Pump, 3/4 HP
This is the complete Sta-Rite JHD-62HL, a J/JB Series unit built as a high head centrifugal pump at 3/4 HP. Ordering the complete pump rather than individual parts makes sense once a motor has burned out, a casing has cracked, or enough wear parts have failed that a rebuild would cost more than a fresh unit.
A pump in this class is typically replaced rather than rebuilt once the motor windings fail or the pump end has worn past the point where a seal kit would restore performance. built to the same ratings Sta-Rite lists for the JHD-62HL model.
Key Features
- Complete, factory-assembled high head centrifugal pump with motor already mounted
- 3/4 HP motor, 115/230V, single phase
- Cast iron construction for durability under continuous duty
- Rated to 47 GPM max at up to 100 ft max head
- Noryl impeller
- 1-1/4 in NPT suction, 1 in NPT discharge
- Direct replacement for the Sta-Rite JHD-62HL (J/JB Series)
Applications
- Residential and light-commercial water transfer and pressure boosting
- Replacing a Sta-Rite pump that has failed at the motor or pump end rather than a single wear part
- Marine dockside, well house, and utility pump room installations
- Any application already specified for the Sta-Rite JHD-62HL
Specifications
- Brand: Sta-Rite
- Model: JHD-62HL
- Part Type: Complete Pump (high head centrifugal pump)
- Series: J/JB Series
- Motor: 3/4 HP, 115/230V, single phase
- Flow: 47 GPM max
- Max Head: 100 ft max head
- Body Material: Cast iron
- Impeller Material: Noryl
- Connections: 1-1/4 in NPT suction, 1 in NPT discharge
- Condition: New
Frequently Asked Questions
Q: Is this pump self-priming?
Sta-Rite jet and centrifugal pumps in this class are self-priming once the pump body and suction line are properly primed with water at startup; follow the priming instructions in the pump manual.
Q: Where should this pump be installed?
In a dry, accessible location such as a well house, basement, or utility room, close to the water source it is drawing from.
Q: Does this pump include the motor?
Yes. This is the complete pump as Sta-Rite builds it, with the motor already mounted and matched to the pump end; no separate motor purchase is needed.
Q: Will this fit if my old pump has a different model number?
Only if the model numbers match exactly. Sta-Rite uses closely related model codes across different horsepower and voltage points in the same series, so confirm the full model number on the old pump nameplate before ordering.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct pump.
CLRMarine
