Sta-Rite J212-24E Pressure Regulator Valve Assembly
The Sta-Rite J212-24E is a replacement pressure regulator valve assembly for Sta-Rite PL-Series convertible jet pumps. It controls internal pressure in the pump system, and a stuck or worn one can cause a pump to short-cycle, run continuously, or deliver inconsistent pressure at the taps.
A pressure regulator that has worn or stuck open or closed is a common cause of a pump that cycles on and off too often, or that never quite builds full pressure. Inspect the diaphragm and seat inside the assembly for wear or debris before assuming the pressure switch itself is at fault.
Key Features
- Genuine-fit Sta-Rite J212-24E replacement pressure regulator valve assembly
- Controls internal system pressure and cycling behavior
- Direct fit replacement for the original Sta-Rite part
Applications
- Fixing a pump that short-cycles or will not build full pressure
- Servicing the Sta-Rite pump system this part is cataloged for
- Routine replacement of a worn or debris-clogged regulator valve
Specifications
- Brand: Sta-Rite
- Manufacturer Part Number: J212-24E
- Part Type: Pressure Regulator Valve Assembly
- Quantity Per System: 1
- Condition: New
Frequently Asked Questions
Q: Can this be cleaned instead of replaced?
Debris can sometimes be flushed from the seat, but a worn diaphragm or seat should be replaced rather than cleaned, since wear does not reverse.
Q: Does this affect the pressure switch settings?
No, the pressure switch and this regulator valve control different things; replacing this part does not require changing switch settings unless the old setup was compensating for the worn valve.
Q: What symptoms point to this part rather than the pressure switch?
Inconsistent pressure at the taps with a pressure switch that is cycling normally usually points to the regulator valve rather than the switch itself.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct pressure regulator valve.