Sta-Rite HP30G-02 Complete High-pressure Booster Pump, 2 HP
Sta-Rite builds the HP30G-02 as a factory-assembled high-pressure booster pump, 2 HP, in its HP Series (Signature 2000). Every wetted part, the motor, and the pump end are matched at the factory to the ratings on the nameplate, which is worth confirming against the old unit before ordering a replacement of this exact model.
Because this is a complete pump rather than a single part, installation is mostly a matter of matching the plumbing connections and electrical supply to the old unit. Check the voltage and horsepower on the old pump nameplate against this listing before ordering to avoid a mismatch.
Key Features
- Complete, factory-assembled high-pressure booster pump with motor already mounted
- 2 HP motor, 115/230V, single phase
- Cast iron construction for durability under continuous duty
- Rated to 30 GPM
- 7 stages design for added pressure or lift
- Direct replacement for the Sta-Rite HP30G-02 (HP Series (Signature 2000))
Applications
- Boosting house or irrigation pressure from a storage tank or low-pressure main
- Replacing a Sta-Rite pump that has failed at the motor or pump end rather than a single wear part
- Marine dockside, well house, and utility pump room installations
- Any application already specified for the Sta-Rite HP30G-02
Specifications
- Brand: Sta-Rite
- Model: HP30G-02
- Part Type: Complete Pump (high-pressure booster pump)
- Series: HP Series (Signature 2000)
- Motor: 2 HP, 115/230V, single phase
- Flow: 30 GPM
- Stages: 7 stages
- Body Material: Cast iron
- Condition: New
Frequently Asked Questions
Q: Can I rebuild my existing pump instead of replacing the whole unit?
If only the seal, gaskets, or impeller have failed, a seal or overhaul kit is usually the cheaper fix. A complete pump like this one makes sense once the motor or pump body itself has failed.
Q: What voltage does this pump run on?
115/230V, single phase. Confirm your electrical supply matches before wiring it in.
Q: Is this pump self-priming?
Submersible pumps do not need priming since the pump stays submerged below the water line in normal operation.
Q: Where should this pump be installed?
In a dry, accessible location such as a well house, basement, or utility room, close to the water source it is drawing from.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct pump.
CLRMarine
