Sta-Rite C105-92PS Impeller
This is the C105-92PS impeller, sized for Sta-Rite Dyna-Glas/Dyna-Max Series in-ground pool and spa pumps. Impellers wear from cavitation, sand and grit in the water, and simple age, and a worn one is one of the most common reasons a Sta-Rite pump loses pressure or flow even though the motor still runs fine.
Because the impeller sits directly on the motor shaft, this is also the part most likely to need replacing after the pump has run dry or ingested debris that jammed or chipped the vanes. Inspect the mechanical seal and diffuser or volute for matching damage at the same time, since a failed impeller often takes the seal with it.
Key Features
- Genuine-fit Sta-Rite C105-92PS replacement impeller
- Molded for a balanced, vibration-free spin on the motor shaft
- Built for Sta-Rite Dyna-Glas/Dyna-Max Series in-ground pool and spa pumps
- Restores lost flow and pressure caused by a worn or chipped impeller
- Direct fit replacement, no pump modification required
Applications
- Restoring flow and pressure on a Sta-Rite pump that has lost performance
- Rebuilding Sta-Rite Dyna-Glas/Dyna-Max Series in-ground pool and spa pumps
- Replacing an impeller chipped or jammed by sand, grit, or a dry-run incident
- Routine wear-part replacement on residential and light-commercial water pumps
Specifications
- Brand: Sta-Rite
- Manufacturer Part Number: C105-92PS
- Part Type: Impeller
- Fits: Sta-Rite Dyna-Glas/Dyna-Max Series in-ground pool and spa pumps
- Quantity Per Pump: 1
- Condition: New
Frequently Asked Questions
Q: Do I need to replace the seal at the same time?
Not always, but inspect it while the pump is open. An impeller that failed from a dry-run event or debris often damaged the mechanical seal as well, and it is cheaper to replace both while the pump is already apart.
Q: Will this impeller fit a different horsepower pump in the same series?
No. Sta-Rite Dyna-Glas/Dyna-Max Series in-ground pool and spa pumps use different impeller sizes for different horsepower ratings even within the same body style, so match the part number exactly rather than just the pump family.
Q: What causes an impeller to wear out?
Sand and grit in the water, cavitation from running against a closed or restricted line, and simple age all wear the vanes down over time. Running the pump dry, even briefly, can chip or crack an impeller outright.
Q: Can a chipped impeller be repaired instead of replaced?
No. A chipped or cracked impeller is out of balance and should be replaced rather than repaired; running an unbalanced impeller accelerates wear on the shaft seal and motor bearings.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct impeller.
CLRMarine
