Sta-Rite A100FLL Motor
The Sta-Rite A100FLL is a 1-1/2 HP replacement motor built for Sta-Rite jet pumps, designed to bolt straight onto the pump end in place of a motor that has burned out, seized, or developed a bad bearing.
A motor is usually replaced rather than rewound once the windings have burned or a bearing has failed, since a new motor costs little more than a professional rewind and comes with a fresh warranty. Confirm horsepower, voltage, and shaft/mounting dimensions against the old motor before ordering, since Sta-Rite uses more than one motor frame across its jet pump lines.
Key Features
- Genuine-fit Sta-Rite A100FLL replacement jet pump motor
- 1-1/2 HP rating, 115/230V dual-voltage, single phase
- Bolts directly to the pump end in place of the original motor
- Direct fit replacement, no pump-end modification required
Applications
- Replacing a Sta-Rite jet pump motor that has burned out or seized
- Rebuilding a jet pump after a bearing failure in the motor
- Routine motor replacement on residential well and pressure systems
Specifications
- Brand: Sta-Rite
- Manufacturer Part Number: A100FLL
- Part Type: Jet Pump Motor
- Horsepower: 1-1/2 HP
- Voltage: 115/230V, single phase
- Condition: New
Frequently Asked Questions
Q: How do I know if I need a new motor instead of a seal kit?
A motor that hums but will not turn, that trips its breaker repeatedly, or that has a seized or noisy bearing needs replacing. A pump that runs fine but leaks or loses pressure usually needs a seal kit or impeller instead.
Q: Will this motor fit any Sta-Rite jet pump of the same horsepower?
Only if the mounting frame and shaft dimensions match. Confirm against the original motor before ordering, since Sta-Rite has used more than one motor frame across its jet pump lines.
Q: Is this a dual-voltage motor?
Yes, it runs on 115V or 230V single-phase power; confirm the wiring is set for the voltage actually supplied before startup.
Q: Does this include the pump end?
No, this is the motor only. It bolts onto the existing pump end in place of the original motor.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct motor.
CLRMarine
