Sta-Rite 7P4DO2JL Complete 4 In Submersible Well Pump, 3/4 HP
The Sta-Rite 7P4DO2JL is a complete 4 in submersible well pump, rated at 3/4 HP. It ships as a ready-to-plumb unit with its motor already mounted, so it drops in as a direct replacement for a worn-out or failed pump of the same model rather than a rebuild project.
Because this is a complete pump rather than a single part, installation is mostly a matter of matching the plumbing connections and electrical supply to the old unit. Check the voltage and horsepower on the old pump nameplate against this listing before ordering to avoid a mismatch.
Key Features
- Complete, factory-assembled 4 in submersible well pump with motor already mounted
- 3/4 HP motor
- Direct replacement for the Sta-Rite 7P4DO2JL
Applications
- Residential deep well water supply where the pump hangs below the water line
- Replacing a Sta-Rite pump that has failed at the motor or pump end rather than a single wear part
- Marine dockside, well house, and utility pump room installations
- Any application already specified for the Sta-Rite 7P4DO2JL
Specifications
- Brand: Sta-Rite
- Model: 7P4DO2JL
- Part Type: Complete Pump (4 in submersible well pump)
- Motor: 3/4 HP
- Condition: New
Frequently Asked Questions
Q: What voltage does this pump run on?
Check the nameplate on the unit for the exact voltage and phase before wiring it in.
Q: Is this pump self-priming?
Submersible pumps do not need priming since the pump stays submerged below the water line in normal operation.
Q: Where should this pump be installed?
Inside the well casing, fully submerged below the water line, on the drop pipe sized for this pump.
Q: Does this pump include the motor?
Yes. This is the complete pump as Sta-Rite builds it, with the motor already mounted and matched to the pump end; no separate motor purchase is needed.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct pump.
CLRMarine
