Pulsafeeder NCKA3HPAP1 Chem-Tech XP KOPkit
The Pulsafeeder NCKA3HPAP1 is the genuine Chem-Tech KOPkit (Keep On Pumping kit) for Chem-Tech Series XP and XPV peristaltic metering pumps that use the size 3 high pressure tube. That covers the 9 and 15 GPD XP pumps and the 17 GPD XPV. The kit carries a complete clear PVC pump head with its roller assembly and tubing, with 1/4 in OD tubing connections, so the whole wet side of the pump is renewed at once.
A peristaltic pump that has been running on the same head for years usually has rollers that are wearing the tube faster than it should, and a head that has been marked by chemical. Fitting the full KOPkit brings the pump back to new condition in a few minutes without tools, which is why keeping one on the shelf is standard practice for pumps that cannot be allowed to stop.
Key Features
- Genuine Chem-Tech KOPkit
- For XP and XPV pumps with the size 3 high pressure tube
- Complete pump head with roller assembly
- Tubing included
- 1/4 in OD tubing connections
- Tool free installation
Applications
- Chem-Tech XP 9 and 15 GPD pumps
- Chem-Tech XPV 17 GPD pumps
- Preventive maintenance and critical spares
- Water treatment and chlorination
- Pool, spa and water conditioning feed
- Marine and industrial chemical dosing
Specifications
- Brand: Pulsafeeder Chem-Tech
- Manufacturer Part Number: NCKA3HPAP1
- Part Type: KOPkit, head and tube
- Tube Size: 3
- Pressure Configuration: High pressure
- Head Material: Clear PVC
- Connection: 1/4 in OD tubing
- Fits: Chem-Tech XP009, XP015 and XPV017
- Quantity Needed: One per pump
- Condition: New
Frequently Asked Questions
Q: How do I know my pump uses a size 3 tube?
The model number shows the flow rate. The 9 and 15 GPD XP pumps and the 17 GPD XPV use the size 3 tube, and the pump data label confirms it.
Q: Can I buy just the tube instead?
Yes, replacement tube assemblies are available on their own, but when the rollers are worn the full kit gives a longer tube life.
Q: Is there anything to adjust after fitting?
No tube adjustment is needed. Lubricate the tube lightly where the rollers run, reconnect the tubing and prime the pump.
Q: Why keep a kit on the shelf?
A split tube stops feed immediately. Having the kit ready on the shelf turns a lost day into a short swap.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct KOPkit.
CLRMarine
