Pulsafeeder LC04SA-PHC1-XXX Metering Pump
The Pulsafeeder LC04SA-PHC1-XXX is a Pulsatron Series C electronic solenoid diaphragm metering pump rated at 24 gallons per day (1.00 GPH) against up to 80 PSI, powered from 115 VAC, 50/60 Hz. The liquid end is glass-filled polypropylene (GFPPL) with CSPE seats and O-rings and ceramic check valve balls, connected with 1/4 in ID x 3/8 in OD tubing. GFPPL is the general purpose head material and handles most water treatment chemicals, including cooling tower and boiler treatment programs.
Control is by manual on/off with on-line adjustable stroke length (10:1 turndown), at up to 125 strokes per minute. The diaphragm pump design is sealless and leak free at the liquid end, guided ball check valves help it prime and hold prime, and the drive is fully enclosed with thermal overload protection on the solenoid. When the time comes to service it, the matching rebuild kit is KOPkit K4PHC1, which renews the head, diaphragm and both valve cartridges in one go.
Key Features
- Pulsatron Series C solenoid diaphragm metering pump
- 24 GPD (1.00 GPH) maximum output
- Up to 80 PSI discharge pressure
- GFPPL head with CSPE seats and ceramic balls
- Sealless, leak free liquid end
- Guided ball check valves for reliable priming
- Solenoid protected by auto reset thermal overload
Applications
- Water and wastewater treatment
- Cooling tower and boiler water treatment
- Chlorination and disinfection
- PH adjustment and chemical feed
- Marine and industrial dosing systems
- Replacing a worn pump with the same model
Specifications
- Brand: Pulsafeeder Pulsatron
- Series: Series C
- Model: LC04SA-PHC1-XXX
- Maximum Flow: 24 GPD (1.00 GPH)
- Maximum Pressure: 80 PSI
- Power: 115 VAC, 50/60 Hz, single phase
- Head Material: Glass-filled polypropylene (GFPPL)
- Seats and O-Rings: CSPE
- Check Valve Balls: Ceramic
- Connection: 1/4 in ID x 3/8 in OD tubing
- Maximum Stroke Rate: 125 strokes per minute
- Reproducibility: Plus or minus 3 percent of maximum capacity
- Maximum Viscosity: 1,000 cP
- Rebuild Kit: KOPkit K4PHC1
- Condition: New
Frequently Asked Questions
Q: How do I set the output?
Start with the stroke length and stroke rate at a mid setting, measure what the pump actually delivers with a calibration column or by timing a draw down, then adjust. Output is proportional to both settings.
Q: Can it be mounted outdoors?
The enclosure is water resistant for indoor and outdoor installations, but keep it out of direct sun and use UV resistant black discharge tubing if the tubing is exposed.
Q: Why does the pump lose prime on sodium hypochlorite?
Hypochlorite releases gas that collects in the head. Mounting the pump with a flooded suction and bleeding the head regularly helps, and a degassing valve is the permanent fix.
Q: What is the most common wear item?
The check valve cartridges, followed by the diaphragm. A slow drop in output usually points to a valve that is not seating cleanly.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct metering pump.
CLRMarine
