Oberdorfer 1010.2 Adapter – OEM Pump Replacement Part
This is the genuine Oberdorfer 1010.2 adapter. It is a machined interface part, and the value of a factory adapter is that the register bore and the bolt pattern are cut to the same tolerances as the pump they mate to.
Check the fastener holes and the register bore for damage before reusing an adapter. Elongated holes let the assembly shift under load.
Confirm the motor frame or mounting standard against your installation before ordering, as adapters are specific to both the pump and the driver.
Key Features
- Genuine Oberdorfer 1010.2 adapter
- Factory material specification
- Machined register and bolt pattern
- Holds pump and driver concentric without field alignment
- Direct replacement for a damaged or corroded original
Applications
- Close coupled pump and motor assemblies
- Hydraulic motor driven marine pumps
- Pedestal and bracket mounted installations
- Industrial circulation and transfer pump builds
- Replacement of corroded mounting interfaces
Specifications
- Brand: Oberdorfer
- Manufacturer: Ingersoll Rand
- Manufacturer Part Number: 1010.2
- Part Type: Adapter
- Condition: New
Frequently Asked Questions
Q: Does it fit any motor of the right horsepower?
No. Frame size and shaft dimensions are what matter, not horsepower, so match the frame standard rather than the rating.
Q: Do I still need to check alignment after fitting?
A close coupled adapter sets it for you, but confirm the register seated fully and the fasteners pulled down evenly.
Q: Are fasteners included?
Treat it as the casting alone unless stated otherwise, and plan on new stainless fasteners if the originals are corroded.
Q: Why does the coupling wear quickly?
Usually a register that is not seating, debris between the faces, or a bent shaft. Check all three before fitting another coupling.
Not sure this is the right part? Send us a Picture of the pump plate on your pump and the CLR Marine team will confirm the correct adapter before you order.
CLRMarine
