MTH Pumps T41P-SS LE 56C SS
- Capacities to 24 GPM
- Heads to 600 Feet
- Low NPSH Requirements
- Ports 1"
MTH T41 Series Pump End Only
By combining the latest concepts in hydraulic turbine pump design with precision computer controlled manufacturing, the T41/E41 Series pumps deliver high efficiency operation even at low NPSH. Costs are controlled by efficient manufacturing processes and highly optimized pump designs. Maintenance costs are kept to a minimum by combining an easily serviceable design with the use of high quality components to provide long life.
MTH E41 and T41 Series pumps utilize the same major components, and are identical in performance, but utilize different motors. E41 pumps are restricted to close-coupled operation on our own custom designed D3 motors. The D3 motors have a dual C-face with two pole 50//60 Hz ratings as well as an upgraded heavy-duty bearing for extended service life. The three-phase motors have a TEFC IP55 enclosure and power capability from 1/3HP thru 3HP, while the single-phase motors have an ODP IP21 enclosure and range from 1/3HP to 2HP. All D3 motors feature a 304 stainless steel shaft and CE mark approval. T41 pumps can accept most commonly available motors through the use of close or flexible coupling. For wider fluid compatibility, T41 units 3HP and under feature a protective motor shaft sleeve, while motors 5HP and over utilize a corrosion resistant 316 stainless steel shaft. Motors for the T41 Series come in ODP, TEFC, and Explosion-proof enclosures and allow operation at two pole or four pole speeds (3450/2880 or 1750/1450 RPM) ranging from 1/3HP to 3HP (C3/P3 single or three phase) and 5HP to 15HP (C15/P15 three phase only).
Steep Operating Characteristics: Near-constant capacity is maintained over wide variations in pressure. High shut-off pressure overcomes temporary line resistance.
Self-Adjusting Impeller: A hydrodynamic film on each side of the impeller positions it for long life. The impeller exerts no thrust load on bearings. Pump operates equally well in a vertical or horizontal position.
Mechanical Seals: Bronze fitted pumps have Buna N elastomers, high temperature carbon, and ceramic seats for best hot water service. Optional seats and materials are also available.
300# Case Working Pressure: Rigid structure is designed for maximum casing strength.
100% Tested: Every pump is fully tested to verify performance prior to shipment.
Volatile Fluid Handling: Turbine impeller handles vapors in excess of 20% by volume, minimizing the possibility of vapor locks.
"O"Ring Gaskets: "O"ring seals are used throughout the E41/T41 Series pumps to assure sealing and ease of service.
Water Flinger: A water flinger provides added protection to ball bearings in the event of seal leakage.
Simple Construction: E41/T41 Series pumps contain only three major components, allowing for easy service.
End Suction • Top Discharge: E41/T41 Series pumps fit into small spaces easily. Discharge can be rotated to 90 degree, 180 degree and 270 degree positions.
Best Efficiency: New pump design optimizes efficiency for each size.
Non-Cavitating: E41/T41 series pumps may be operated under adverse inlet conditions without audible or measurable cavition.
Low NPSH: New inlet design provides superior fluid handling ability at low head inlet conditions.
CLRMarine
