MP Pumps 22700 Sleeve
A shaft or drive sleeve protects the pump shaft from wear at the seal or bearing location and helps transmit drive torque between coupled components.
Always match by the MP Pumps part number 22700 listed on your equipment parts diagram, since dimensions and material vary across the MP Pumps lineup even for parts with the same common name.
Key Features
- Genuine MP Pumps replacement sleeve
- Sized to fit a specific shaft diameter and pump model
- Material varies by part number
Applications
- Protecting the shaft at the seal location during a rebuild
- Restoring proper drive coupling engagement
Specifications
- Manufacturer: MP Pumps
- Part Number: 22700
- Part Type: Sleeve
Frequently Asked Questions
Q: What causes this part to wear out?
Wetted components wear from normal operation, cavitation, dry running, or abrasive material in the pumped fluid. Regular inspection catches wear before it causes a bigger failure.
Q: Should I replace other parts at the same time?
When servicing a pump wet end, it is common practice to also replace the mechanical seal, gaskets, and O-rings at the same time to avoid a repeat teardown.
Q: What tools do I need to install this?
Most MP Pumps wet-end parts install with standard hand tools. Always relieve system pressure and disconnect power before servicing a pump.
Q: Can I use this part on a different MP Pumps model?
Wet-end parts are sized to a specific pump model and configuration. Confirm against your pump nameplate before ordering, or send us a picture and we will verify.
CLRMarine
