Jabsco 777-9003 Bronze Pedestal Pump, Nitrile Impeller, Face Seal
The Jabsco 777-9003 Bronze Pedestal Pump, Nitrile Impeller, Face Seal combines the flow, pressure and electrical characteristics of its spec sheet with the corrosion resistance a marine installation demands. Its full specification is up to 32 GPM at 3000 RPM/10 ft head (nitrile impeller values run about 10% below neoprene), bronze body, stainless steel shaft, shielded ball bearings, nitrile impeller, mechanical face seal, 1 in NPT internal ports, replaceable wearplate.
Installation and long-term reliability both come down to matching this unit to the plumbing or ducting it is replacing, and to protecting the electrical side with a correctly sized fuse or breaker rather than relying on the unit alone. Like any Jabsco product, it draws on decades of marine-specific engineering, so a factory replacement performs to the same standard as the original equipment it replaces, without the compromises of a generic substitute.
Key Features
- Up to 32 GPM at 3000 RPM/10 ft head (nitrile impeller values run about 10% below neoprene)
- Bronze body
- Stainless steel shaft
- Shielded ball bearings
- Nitrile impeller
- Mechanical face seal
Applications
- Direct replacement for the equivalent Jabsco Bronze Pedestal Pump
- New installations where this specification is called for
- Marine, RV and comparable mobile applications
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 777-9003
- Product Type: Bronze Pedestal Pump
- Condition: New
Frequently Asked Questions
Q: Can this run dry without damage?
Check the run-dry note in the specifications above. Where it is listed as run-dry capable, brief dry running will not damage it, but running dry for extended periods is never good practice.
Q: Will this replace my existing unit without changing the plumbing or ducting?
In most cases yes, provided the port size matches. Compare the port dimensions in the specifications above against what you are removing before ordering.
Q: Is this suitable for continuous duty?
Check the duty cycle in the specifications above. Some models in this family are intermittent-duty only and will trip their thermal protection if run continuously.
Q: Do you carry service parts for this unit?
Yes, service parts for this product are stocked separately. Send us your unit model number and we can point you to what you need.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct pump.
CLRMarine
