Jabsco 777-9001 Bronze Pedestal Pump, Neoprene Impeller, Face Seal
The Jabsco 777-9001 Bronze Pedestal Pump, Neoprene Impeller, Face Seal is built for reliable service aboard a boat, where space, current draw and duty cycle all matter more than they do ashore. Its full specification is up to 35 GPM at 3000 RPM/10 ft head, bronze body, stainless steel shaft, shielded ball bearings, neoprene impeller, mechanical face seal, 1 in NPT internal ports, replaceable wearplate.
Installation and long-term reliability both come down to matching this unit to the plumbing or ducting it is replacing, and to protecting the electrical side with a correctly sized fuse or breaker rather than relying on the unit alone. Like any Jabsco product, it draws on decades of marine-specific engineering, so a factory replacement performs to the same standard as the original equipment it replaces, without the compromises of a generic substitute.
Key Features
- Up to 35 GPM at 3000 RPM/10 ft head
- Bronze body
- Stainless steel shaft
- Shielded ball bearings
- Neoprene impeller
- Mechanical face seal
Applications
- Direct replacement for the equivalent Jabsco Bronze Pedestal Pump
- New installations where this specification is called for
- Marine, RV and comparable mobile applications
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 777-9001
- Product Type: Bronze Pedestal Pump
- Condition: New
Frequently Asked Questions
Q: What is included in the box?
The unit itself, complete and ready to plumb or wire in. Mounting hardware and hose fittings vary by kit; check the specifications above for what is called out for this model.
Q: What size fuse or breaker should I use?
Size it to the maximum current draw listed in the specifications above, using a slow-blow marine-rated fuse or breaker rather than an automotive one.
Q: Can this run dry without damage?
Check the run-dry note in the specifications above. Where it is listed as run-dry capable, brief dry running will not damage it, but running dry for extended periods is never good practice.
Q: Will this replace my existing unit without changing the plumbing or ducting?
In most cases yes, provided the port size matches. Compare the port dimensions in the specifications above against what you are removing before ordering.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct pump.
CLRMarine
