Jabsco 59451-1012 Ultra-Max Water Pressure System, 12V
The Jabsco 59451-1012 Ultra-Max Water Pressure System, 12V combines the flow, pressure and electrical characteristics of its spec sheet with the corrosion resistance a marine installation demands. Its full specification is 3.5 GPM, 20-40 PSI cut-in/cut-out, 12V DC, 8A draw, 12A fuse, quadruple-diaphragm Par-Max 3 pump with integral accumulator tank on a single self-contained base, 1/2 in ID hose barb ports, thermal overload and ignition protection, self-priming to 10 ft, safe to run dry, mounts vertically or horizontally.
Installation and long-term reliability both come down to matching this unit to the plumbing or ducting it is replacing, and to protecting the electrical side with a correctly sized fuse or breaker rather than relying on the unit alone. Like any Jabsco product, it draws on decades of marine-specific engineering, so a factory replacement performs to the same standard as the original equipment it replaces, without the compromises of a generic substitute.
Key Features
- 3.5 GPM
- 20-40 PSI cut-in/cut-out
- 12V DC
- 8A draw
- 12A fuse
- Quadruple-diaphragm Par-Max 3 pump with integral accumulator tank on a single self-contained base
Applications
- Direct replacement for the equivalent Jabsco Ultra-Max Water Pressure System
- New installations where this specification is called for
- Marine, RV and comparable mobile applications
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 59451-1012
- Product Type: Ultra-Max Water Pressure System
- Condition: New
Frequently Asked Questions
Q: Do you carry service parts for this unit?
Yes, service parts for this product are stocked separately. Send us your unit model number and we can point you to what you need.
Q: What is included in the box?
The unit itself, complete and ready to plumb or wire in. Mounting hardware and hose fittings vary by kit; check the specifications above for what is called out for this model.
Q: What size fuse or breaker should I use?
Size it to the maximum current draw listed in the specifications above, using a slow-blow marine-rated fuse or breaker rather than an automotive one.
Q: Can this run dry without damage?
Check the run-dry note in the specifications above. Where it is listed as run-dry capable, brief dry running will not damage it, but running dry for extended periods is never good practice.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct system.
CLRMarine
