Jabsco 3286-0000 Slinger
The Jabsco 3286-0000 is a genuine replacement slinger. It is a small rubber or neoprene flinger fitted just ahead of the bearing housing. Spinning with the shaft, it throws any fluid that gets past the primary seal outward and away from the bearing cavity, keeping water out of the grease and off the bearing races.
Jabsco has used this part across a range of pump models over the years without always changing the part number to match, so the safest way to confirm fit is against the number stamped or molded on your existing part, or the number on your pump data plate, rather than by the pump model alone. It is supplied as a genuine replacement, made to the same material specification and dimensions as the original part it replaces.
Key Features
- Genuine Jabsco replacement slinger
- Material: Neoprene/rubber
- Made to original Jabsco dimensions and tolerances
- Direct fit, no modification required
Applications
- Routine maintenance and rebuild of Jabsco marine pumps
- Restoring correct operation after wear or a failure
- Keeping a spare on board for offshore or extended-cruise repairs
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 3286-0000
- Part Type: Slinger
- Material: Neoprene/rubber
- Quantity Used: One per pump (typical)
- Condition: New
Frequently Asked Questions
Q: What causes this part to fail?
Normal wear from continuous duty, age hardening of rubber components, or a dry-run event are the most common causes.
Q: Do you sell a kit that includes this part with the related gasket or seal?
If a combination kit exists for this pump we carry it separately. Send us your pump data plate and we can point you to it.
Q: How do I know this is the right part for my pump?
Match the number stamped or molded on the old part to 3286-0000 if it is legible. If it has worn away, send us a picture of your pump data plate and we will confirm before you order.
Q: Why is no specific pump model listed?
Jabsco has reused this part number across several pump families over the years. Confirming by the part number itself, rather than by pump model, is the more reliable method.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct slinger.
CLRMarine
