The Jabsco 30414-0000 is a genuine Jabsco replacement shaft used in Jabsco raw water pumps supplied on marine generator sets. The shaft carries the impeller through the pump body, transmits power from the drive, and provides the running surface for the shaft seal and bearings.
A shaft that is grooved at the seal, pitted, bent or worn at the impeller drive will ruin new seals and impellers quickly. Replacing it during a rebuild restores a smooth sealing surface and a correct impeller fit, and it is the right time to renew the seal and bearings too.
Key Features
- Genuine Jabsco replacement shaft
- Precision-ground to Jabsco tolerances
- Restores the seal surface and impeller fit
- Helps new seals and bearings last
- Direct replacement for the original shaft
Applications
- Marine generator raw water pumps that list part 30414-0000
- Jabsco pumps that list part 30414-0000
- Pump rebuilds and overhauls
- Marine, industrial and utility pump service
- Spare parts kits for boats and service vehicles
Specifications
- Part Number: 30414-0000
- Part Type: Pump Shaft
- Brand: Jabsco
Frequently Asked Questions
Q: How can I tell if the shaft is worn?
Look for a groove where the seal rides, pitting, a bent shaft or a loose fit at the impeller drive.
Q: Should I replace seals and bearings too?
Yes. Old seals and bearings can damage a new shaft quickly, so renew them together.
Q: Can I install the shaft myself?
Most owners with basic mechanical skills can, using the pump manual. Press-fit bearings may need a small press.
Q: What causes shaft wear?
Leaking seals, dry running, misalignment and pumping liquids the shaft material was not chosen for.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct pump shaft.
CLRMarine
