The Jabsco 3010-1014 is a phenolic plastic flexible impeller pedestal pump with a Viton impeller, lip-type seal and 5/8 inch ID hose barb ports, supplied as a bare-shaft pump without a motor. It delivers a nominal 2.2 GPM (10 L/min) at 1500 RPM, self-primes from dry up to 4.9 feet (1.5 m) and tolerates debris.
The only metal parts are the 316 stainless steel shaft and drive pin, which gives excellent corrosion resistance to a wide range of chemical solutions, including ammonia, barium, many cyanide solutions, silver nitrate and photographic fixers and developers. The Viton impeller is rated from 60 to 180 F. Suction lines must be airtight, and the pump must not run dry for more than 30 seconds.
Key Features
- Phenolic plastic pump body
- Viton flexible impeller
- 316 stainless steel shaft and drive pin are the only metal parts
- 5/8 in ID hose barb ports
- Bare-shaft pedestal for single or variable speed drive
- Self-primes up to 4.9 ft
Applications
- Photographic and laboratory chemical transfer
- Corrosive solution circulation
- OEM equipment where plastic wetted parts are preferred
- Small-flow variable speed pumping
Specifications
- Part Number: 3010-1014
- Pump Body: Phenolic plastic
- Impeller: Viton
- Shaft and Drive Pin: 316 stainless steel
- Seal: Lip type
- Ports: 5/8 in ID hose barb
- Nominal Flow: 2.2 GPM (10 L/min) at 1500 RPM
- Dry Self-Priming: Up to 4.9 ft (1.5 m)
- Impeller Temperature Range: 60 to 180 F (15 to 82 C)
- Configuration: Pedestal pump, less motor
Frequently Asked Questions
Q: Why choose a phenolic pump over bronze?
Phenolic plastic resists many chemicals that would corrode bronze, and with only the stainless shaft and pin in contact with the liquid, it suits corrosive solutions.
Q: Can it be driven at different speeds?
Yes. It is suited to single or variable speed operation from a belt, gearbox or coupled motor.
Q: Is the Viton impeller good for all chemicals?
No impeller suits everything. Check your liquid's compatibility with Viton, phenolic and 316 stainless before use.
Q: How do I confirm it matches my old pump?
Send us a photo of the pump plate and our team will confirm the model.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct phenolic pedestal pump.
CLRMarine
