The Jabsco 23095-0007-B is a genuine Jabsco 23095-0007 impeller kit in plain bulk packaging for Ballast King 22610 series reversible ballast pumps. It is the same impeller as the retail kit, packed simply for service departments and owners who keep spares.
The Ballast King impeller is a 6-blade urethane design, 2 inches (51 mm) in diameter and 1 inch (25 mm) wide, with a plastic insert for a 5/16 inch (8 mm) shaft. Ballast pumps run hard and often, and a worn impeller shows up as slower fill and drain times. Replacing it restores full flow so ballast changes stay quick between sets.
Key Features
- Genuine Jabsco 23095-0007 impeller in bulk packaging
- 6-blade urethane impeller built for ballast pump duty
- 2 in (51 mm) diameter by 1 in (25 mm) wide
- Plastic insert for a 5/16 in (8 mm) shaft
- Restores fast fill and drain times
Applications
- Jabsco Ballast King 22610 series reversible ballast pumps
- Wake and surf boat ballast systems
- Routine ballast pump maintenance
- Spare impeller for the boat or shop
Specifications
- Part Number: 23095-0007-B
- Packaging: Bulk, single kit
- Impeller Material: Urethane
- Number of Blades: 6
- Diameter: 2 in (51 mm)
- Width: 1 in (25 mm)
- Shaft: 5/16 in (8 mm)
- Insert: Plastic
- Fits: Ballast King 22610 series pumps
Frequently Asked Questions
Q: What is the difference between -B and -P?
Both are the same genuine impeller. The -B is plain bulk packaging and the -P is the retail pack.
Q: How often should the ballast impeller be changed?
Many owners change it each season. Heavy-use boats may need it sooner if fill times slow down.
Q: Can the pump run after the tank is empty?
Avoid it. Shut the pump off as soon as the tank is empty to protect the impeller from dry running.
Q: Should I remove the impeller for winter storage?
Removing it or loosening the cover keeps the blades from taking a permanent set during long layups.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct ballast king impeller kit.