Jabsco 18916-1060 Pressure Switch, 60 PSI
The Jabsco 18916-1060 is a genuine Jabsco pressure switch set at 60 PSI for a Jabsco diaphragm water pump. It is listed for the Jabsco 32605 and 32900 series pumps.
The pressure switch turns the pump on when a faucet or outlet opens and pressure drops, and off again when the system reaches its set pressure. A worn or failed switch can make the pump cycle rapidly, run on, or fail to start. Isolate power before changing it, and check the system for leaks, since a leak also causes the pump to cycle.
Key Features
- Genuine Jabsco pressure switch
- Listed for 32605 and 32900 Series Pumps
- Automatic on and off control
- Factory pressure setting
- Direct replacement
- Restores normal pump cycling
Applications
- Jabsco 32605 and 32900 Series Pumps
- Freshwater pressure systems
- Washdown systems
- Boats and RVs
- Replacing a failed or pitted switch
- Keeping a spare aboard
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 18916-1060
- Part Type: Pressure switch
- Setting: 60 PSI
- Fits: Jabsco 32605 and 32900 series pumps
- Quantity Needed: One per pump
- Condition: New
Frequently Asked Questions
Q: Can I change to a different pressure setting?
Only to a setting approved for your pump. Too high a setting can overload the motor.
Q: Why does my pump cycle on and off?
Leaks in the system, a failed accumulator or a worn switch are the usual causes.
Q: Should I turn off power first?
Yes. Isolate the power before removing the switch.
Q: Does the pump need a new switch if it will not stop?
It may. Also check for air leaks on the suction side and a closed outlet.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct pressure switch.
CLRMarine
