Jabsco 18777-0001-P Neoprene Impeller Kit
The Jabsco 18777-0001-P is a genuine Jabsco neoprene flexible impeller kit supplied with a 3298-0000 cover gasket. No O-ring is included. It is listed for Jabsco 50410 series engine cooling pumps.
Impellers are wear parts. Replace one when the blades are cracked, torn or have taken a permanent set, when the pump is slow to prime, or after it has run dry even briefly. Lubricate a new flexible impeller with a little water pump grease before fitting it, and fit a new cover gasket or O-ring at the same time.
Key Features
- Genuine Jabsco impeller
- Listed for 50410 Series Pumps
- Factory compound and profile
- Restores flow and priming
- Direct replacement
- Keeps the pump in service
Applications
- Jabsco 50410 Series Pumps
- Jabsco pumps
- Scheduled impeller replacement
- Recovery after the pump has run dry
- Marine and industrial pumps
- Keeping a spare aboard
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 18777-0001-P
- Part Type: Flexible impeller kit
- Impeller Compound: Neoprene
- Kit Contents: Impeller and 3298-0000 cover gasket, no O-ring
- Fits: Jabsco 50410 series engine cooling pumps
- Quantity Needed: One per pump
- Condition: New
Frequently Asked Questions
Q: What causes blades to break off?
Running dry is the main cause. Find every broken piece so it does not block coolers or strainers.
Q: Should I grease the new impeller?
Yes, a light coat of water pump grease helps it survive the first dry seconds.
Q: Why is my new impeller hard to fit?
The blades must fold the right way. Grease and turning the shaft as you push both help.
Q: Which way should the blades bend?
They bend back against the direction of rotation. Turning the shaft in the running direction while pushing makes fitting easier.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct impeller kit.
CLRMarine
