Jabsco 18754-1004 O-Ring
The Jabsco 18754-1004 is a genuine Jabsco O-ring for a large marine engine cooling pump. It is listed for the Jabsco 17360-1001 engine cooling pump.
O-rings seal the joints between fixed parts of the pump. Once an O-ring has been compressed in service it takes a set and may not reseal, so fit a new one whenever the joint is opened. Check the groove is clean and undamaged, lubricate the O-ring lightly with a grease that suits the material, and make sure it is not twisted or pinched as the parts come together.
Key Features
- Genuine Jabsco O-ring
- Listed for 17360-1001 Pump
- Factory size and cross section
- Seals a fixed joint in the pump
- Restores a leak free assembly
- Inexpensive insurance during a rebuild
Applications
- Jabsco 17360-1001 Pump
- Jabsco pump rebuilds
- Stopping leaks at a fixed joint
- Routine seal replacement
- Marine and industrial pumps
- Keeping service spares
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 18754-1004
- Part Type: O-ring
- Fits: Jabsco 17360-1001 engine cooling pump
- Quantity Needed: Two per pump
- Condition: New
Frequently Asked Questions
Q: How do I know the material is right?
Match the material to the liquid. Nitrile suits oils and fuels, FKM suits many chemicals and higher temperatures, and EPDM suits hot water and many cleaning solutions.
Q: Why does a new O-ring still leak?
Check for a damaged groove, dirt on the sealing faces, or an O-ring that was twisted or pinched on assembly.
Q: Should I keep spares?
Yes. O-rings are small, inexpensive and easy to lose during a rebuild.
Q: Can I reuse the old O-ring?
It is not recommended. A used O-ring has taken a set and often leaks when the joint is reassembled.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct O-ring.
CLRMarine
