Jabsco 18753-0628 Snap Ring
The Jabsco 18753-0628 is a genuine Jabsco snap ring. Jabsco uses this part number on specific models only, so match it against the parts list for the model number on your pump plate before ordering.
Retaining rings snap into a machined groove to locate a bearing, shaft or seal and stop it moving along its axis. A ring that has been sprung open, distorted or corroded will not hold properly, so fit a new one whenever the pump is rebuilt. Use the correct ring pliers, and check the ring is fully seated in its groove all the way round before reassembly.
Key Features
- Genuine Jabsco retaining ring
- Locates the bearing or shaft
- Factory size and spring tension
- Direct replacement part
- Small part that is easy to lose
Applications
- Jabsco pump rebuilds
- Bearing and shaft replacement
- Replacing a distorted or corroded ring
- Marine and industrial pumps
- Keeping service spares
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 18753-0628
- Part Type: Snap ring
- Fits: Specific Jabsco models, confirm against your pump plate
- Quantity Needed: One per pump
- Condition: New
Frequently Asked Questions
Q: How do I know it is seated?
It should sit fully down in its groove all the way round with no gap or tilt.
Q: What happens if it fails?
The bearing or shaft can move, which damages the seal and can let the impeller rub.
Q: Should I keep a spare?
Yes, they are small and easily lost or damaged during a rebuild.
Q: Can I reuse the old ring?
It is better not to. Removing a ring can spread it, and a weakened ring may not hold the bearing in place.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct snap ring.
CLRMarine
