Jabsco 18753-0123 Retaining Ring
The Jabsco 18753-0123 is a genuine Jabsco retaining ring that holds the bearing in the body. It is listed for the Jabsco 2620-1101 and 2620-1103 pumps.
Retaining rings snap into a machined groove to locate a bearing, shaft or seal and stop it moving along its axis. A ring that has been sprung open, distorted or corroded will not hold properly, so fit a new one whenever the pump is rebuilt. Use the correct ring pliers, and check the ring is fully seated in its groove all the way round before reassembly.
Key Features
- Genuine Jabsco retaining ring
- Listed for 2620 Series Pumps
- Locates the bearing or shaft
- Factory size and spring tension
- Direct replacement part
- Small part that is easy to lose
Applications
- Jabsco 2620 Series Pumps
- Jabsco pump rebuilds
- Bearing and shaft replacement
- Replacing a distorted or corroded ring
- Marine and industrial pumps
- Keeping service spares
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 18753-0123
- Part Type: Retaining ring, bearing to body
- Fits: Jabsco 2620-1101 and 2620-1103 pumps
- Quantity Needed: One per pump
- Condition: New
Frequently Asked Questions
Q: How do I know it is seated?
It should sit fully down in its groove all the way round with no gap or tilt.
Q: What happens if it fails?
The bearing or shaft can move, which damages the seal and can let the impeller rub.
Q: Should I keep a spare?
Yes, they are small and easily lost or damaged during a rebuild.
Q: Can I reuse the old ring?
It is better not to. Removing a ring can spread it, and a weakened ring may not hold the bearing in place.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct retaining ring.
CLRMarine
