Jabsco 18724-0000 Retaining Ring
The Jabsco 18724-0000 is a genuine Jabsco retaining ring — the circlip that locates the ball bearing within the pump. Jabsco specifies a particular ring size for each pump in its range, and the correct one is the one listed for your pump, not simply one that looks the same diameter.
That point matters more than it sounds. A ring that is slightly undersized will not seat properly in the groove and can spring free under vibration; one that is slightly oversized will not close down into the groove at all. Either way the bearing ends up unrestrained, and the damage that follows lands on parts far more expensive than the ring.
This ring is the bearing-to-body retaining ring — it sits in the pump body and holds the bearing outer race in place. It is listed by Jabsco for Jabsco 11860 Series clutch pumps. Jabsco uses several different retaining ring sizes across its pump range, so if your pump is not on that list, check the part number against your pump’s own parts list before ordering.
Fit a new ring whenever the bearing comes out. Use circlip pliers rather than screwdrivers, open it only as far as it needs to go, and confirm it has snapped fully home in its groove before reassembling the pump.
Key Features
- Genuine Jabsco (Xylem) service part — correct size and temper for the groove
- Spring steel circlip that positively locates the ball bearing
- Holds shaft and impeller running clearances where they belong
- Inexpensive part to renew during any bearing change or rebuild
- Direct replacement — fit with circlip pliers, no modification
Applications
- Jabsco 11860 Series clutch pumps
- Flexible impeller pump bearing replacement and rebuilds
- Marine engine raw water cooling pump service
Specifications
- Brand: Jabsco (Xylem)
- Manufacturer Part Number: 18724-0000
- Part Type: Bearing retaining ring (circlip)
- Position: Bearing to body
- Sold As: Each
- Condition: New
Frequently Asked Questions
Q: Is this a genuine Jabsco part?
Yes, this is a genuine Jabsco retaining ring, not an aftermarket substitute.
Q: How do I know which retaining ring I need?
Compare this part number to the number on your pump's parts diagram, or send us a picture of the part you are replacing so we can confirm.
Q: When should this ring be replaced?
Replace it whenever it is removed during a bearing or seal service, since a ring that has been sprung open or shows wear may not seat as securely the second time.
Q: Does this fit more than one Jabsco pump model?
Retaining rings of this type are often shared across several Jabsco pump series, so check your pump's own parts list or send us your model number to confirm exact fitment.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct retaining ring.
CLRMarine
