Jabsco 18713-0000 Retaining Ring
The Jabsco 18713-0000 is a genuine Jabsco retaining ring, the spring-steel snap ring that holds the ball bearing captive in a flexible impeller pump. Jabsco uses these rings throughout its pump range to positively locate the bearing so that the shaft, impeller and cam keep the running clearances they were built with.
A retaining ring works by spring tension in a machined groove. That means it only does its job if it is fully seated and still has its original temper. Rings that have been repeatedly removed and refitted, stretched with the wrong pliers, or left to corrode in a saltwater bilge lose tension and can pop out of the groove under vibration.
This ring is the bearing-to-shaft retaining ring — it sits on the shaft and holds the bearing inner race in place. It is listed by Jabsco for Jabsco 11860 Series clutch pumps. Jabsco uses several different retaining ring sizes across its pump range, so if your pump is not on that list, check the part number against your pump’s own parts list before ordering.
Because a failed circlip usually takes the bearing, seal and impeller with it, this is one of the parts most worth renewing rather than reusing. Fit it with proper circlip pliers, seat it fully in the groove, and check it has sprung home before the pump goes back together.
Key Features
- Genuine Jabsco (Xylem) service part — correct size and temper for the groove
- Spring steel circlip that positively locates the ball bearing
- Holds shaft and impeller running clearances where they belong
- Inexpensive part to renew during any bearing change or rebuild
- Direct replacement — fit with circlip pliers, no modification
Applications
- Jabsco 11860 Series clutch pumps
- Flexible impeller pump bearing replacement and rebuilds
- Marine engine raw water cooling pump service
Specifications
- Brand: Jabsco (Xylem)
- Manufacturer Part Number: 18713-0000
- Part Type: Bearing retaining ring (circlip)
- Position: Bearing to shaft
- Sold As: Each
- Condition: New
Frequently Asked Questions
Q: Is this a genuine Jabsco part?
Yes, this is a genuine Jabsco retaining ring, not an aftermarket substitute.
Q: How do I know which retaining ring I need?
Compare this part number to the number on your pump's parts diagram, or send us a picture of the part you are replacing so we can confirm.
Q: When should this ring be replaced?
Replace it whenever it is removed during a bearing or seal service, since a ring that has been sprung open or shows wear may not seat as securely the second time.
Q: Does this fit more than one Jabsco pump model?
Retaining rings of this type are often shared across several Jabsco pump series, so check your pump's own parts list or send us your model number to confirm exact fitment.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct retaining ring.
CLRMarine
