Jabsco 18673-0001-P Neoprene Impeller Kit, 10 Blade
The Jabsco 18673-0001-P is a genuine Jabsco flexible impeller kit with a neoprene impeller. It has 10 blades, a 2 in diameter and a 7/8 in width, with a 1/2 in slotted shaft, pin drive with drive screw. As it turns inside the offset pump body, the blades bend and straighten, drawing liquid in and pushing it out, which is what makes a flexible impeller pump self-priming. It is listed for Jabsco 2620 series bronze pedestal pumps and the 9900-0001 pump. The impeller itself is Jabsco 18673-0001.
Neoprene is the general purpose compound for water, raw water cooling and mildly abrasive liquids. Impellers are wear parts. Replace one when blades are cracked, torn or have taken a permanent set in the curved position, when the pump is slow to prime, or after it has run dry even briefly. Lubricate the new impeller with a little water pump grease before fitting it, and fit a new end cover gasket or O-ring at the same time.
Key Features
- Genuine Jabsco replacement impeller
- Neoprene impeller compound
- 10 blade design
- 2 in diameter by 7/8 in wide
- Listed for 2620 series pumps
- Kit packed for service
Applications
- Jabsco 2620 series pumps
- Raw water and general water transfer
- Scheduled impeller replacement
- Recovery after the pump has run dry
- Marine and industrial pumps
- Keeping a spare aboard or in the shop
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 18673-0001-P
- Part Type: Flexible impeller kit
- Impeller Compound: Neoprene
- Blades: 10
- Diameter: 2 in
- Width: 7/8 in
- Hub and Drive: 1/2 in slotted shaft, pin drive with drive screw
- Fits: Jabsco 2620 series bronze pedestal pumps and the 9900-0001 pump
- Quantity Needed: One per pump
- Condition: New
Frequently Asked Questions
Q: How long does an impeller last?
It depends on hours, temperature and what is being pumped. Many owners replace it every season or at a set number of running hours as insurance.
Q: What causes blades to break off?
Running dry is the main cause. Broken pieces can travel downstream and block coolers or strainers, so find every piece.
Q: Should I grease the new impeller?
Yes, a light coat of water pump grease on the blades and hub helps it survive the first dry seconds before liquid arrives.
Q: Can I change impeller compound?
Yes, where the same impeller is offered in another compound for your pump. Choose the compound for the liquid being pumped.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct impeller kit.
CLRMarine
