Jabsco 18610-0003 Bronze Utility Pump, 1/6 HP 115V, Nitrile Impeller
The Jabsco 18610-0003 is a bronze self-priming utility pump close coupled to a 1/6 HP, 115 VAC motor with an 8 ft cord and grounded plug, with a nitrile flexible impeller and neoprene lip seal. Ports are 1/2 in NPT female with two 3/4 in male garden hose adapters included, flow is about 6 GPM, and it self-primes from a dry lift of about 6 ft, up to 20 ft when wet. The nitrile impeller suits oil based products.
These bronze flexible impeller pumps self-prime, handle small debris and can be mounted in any position, which is why they are used for bilge, washdown, livewell and transfer duty. Keep suction lines airtight so the pump can prime, drain it before freezing weather, and never let it run dry because the impeller depends on the liquid for lubrication.
Key Features
- Bronze flexible impeller pump
- Self-priming
- Tolerates small debris
- Can be mounted in any position
- Genuine Jabsco pump
Applications
- Bilge and compartment pump out
- Deck washdown
- Livewell and bait tank supply
- Freshwater and general transfer
- Marine and RV utility use
- Draining tanks and fixtures
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 18610-0003
- Pump Body: Bronze
- Impeller: Nitrile
- Shaft Seal: Neoprene lip type
- Motor: 1/6 HP, 115 VAC
- Ports: 1/2 in NPT female, two 3/4 in garden hose adapters
- Flow: About 6 GPM
- Dry Suction Lift: About 6 ft
- Cord: 8 ft, grounded plug
- Body Part: 18645-0000
- Condition: New
Frequently Asked Questions
Q: What do I do before freezing weather?
Drain the pump by loosening the end cover so trapped water cannot freeze and crack the body.
Q: What is the main service part?
The impeller. Keep a spare with the matching compound.
Q: Can it be mounted in any position?
Yes, although mounting with the pump head below the motor keeps any seal leakage away from the motor.
Q: Why will it not self-prime?
Almost always an air leak on the suction side. All suction connections must be airtight.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct pump.
CLRMarine
