Jabsco 17954-0001-P Neoprene Impeller Kit, 10 Blade
The Jabsco 17954-0001-P is a genuine Jabsco flexible impeller kit with a neoprene impeller. It has 10 blades, a 2-9/16 in diameter and a 2 in width, with a 3/4 in single flat D drive. As it turns inside the offset pump body, the blades bend and straighten, drawing liquid in and pushing it out, which is what makes a flexible impeller pump self-priming. It is listed for the Jabsco 43210-0001 pump.
Neoprene is the general purpose compound for water, raw water cooling and mildly abrasive liquids. Impellers are wear parts. Replace one when blades are cracked, torn or have taken a permanent set in the curved position, when the pump is slow to prime, or after it has run dry even briefly. Lubricate the new impeller with a little water pump grease before fitting it, and fit a new end cover gasket or O-ring at the same time.
Key Features
- Genuine Jabsco replacement impeller
- Neoprene impeller compound
- 10 blade design
- 2-9/16 in diameter by 2 in wide
- Listed for 43210-0001 pumps
- Kit packed for service
Applications
- Jabsco 43210-0001 pumps
- Raw water and general water transfer
- Scheduled impeller replacement
- Recovery after the pump has run dry
- Marine and industrial pumps
- Keeping a spare aboard or in the shop
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 17954-0001-P
- Part Type: Flexible impeller kit
- Impeller Compound: Neoprene
- Blades: 10
- Diameter: 2-9/16 in
- Width: 2 in
- Hub and Drive: 3/4 in single flat D drive
- Fits: Jabsco 43210-0001 pump
- Quantity Needed: One per pump
- Condition: New
Frequently Asked Questions
Q: Can I change impeller compound?
Yes, where the same impeller is offered in another compound for your pump. Choose the compound for the liquid being pumped.
Q: Why is my new impeller hard to fit?
The blades need to fold the right way. A little grease on the blades and turning the shaft in the running direction as you push helps.
Q: Which way should the blades bend?
They bend back against the direction of rotation as the impeller is pushed into the body. Turning the shaft in the running direction while pushing makes this easy.
Q: How long does an impeller last?
It depends on hours, temperature and what is being pumped. Many owners replace it every season or at a set number of running hours as insurance.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct impeller kit.
CLRMarine
