Jabsco 17935-0001-24 Neoprene Impellers, Carton of 24, 12 Blade
The Jabsco 17935-0001-24 is a genuine Jabsco bulk carton of flexible impellers with a neoprene impeller, supplied as a carton of 24 impeller kits. It has 12 blades, a 3-3/4 in diameter and a 2-1/2 in width, with a 1 in spline drive, brass insert. As it turns inside the offset pump body, the blades bend and straighten, drawing liquid in and pushing it out, which is what makes a flexible impeller pump self-priming. It is listed for Jabsco 6400 and 7420 series engine cooling pumps and the 17810-1000 engine cooling pump. The impeller itself is Jabsco 17935-0001.
Neoprene is the general purpose compound for water, raw water cooling and mildly abrasive liquids. Impellers are wear parts. Replace one when blades are cracked, torn or have taken a permanent set in the curved position, when the pump is slow to prime, or after it has run dry even briefly. Lubricate the new impeller with a little water pump grease before fitting it, and fit a new end cover gasket or O-ring at the same time. The carton of 24 suits fleets, service shops and anyone maintaining several pumps of the same model.
Key Features
- Genuine Jabsco replacement impeller
- Neoprene impeller compound
- 12 blade design
- 3-3/4 in diameter by 2-1/2 in wide
- Listed for 6400, 7420 and 17810 series pumps
- Carton of 24 impeller kits
Applications
- Jabsco 6400, 7420 and 17810 series pumps
- Raw water and general water transfer
- Scheduled impeller replacement
- Recovery after the pump has run dry
- Marine and industrial pumps
- Keeping a spare aboard or in the shop
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 17935-0001-24
- Part Type: Flexible impeller
- Impeller Compound: Neoprene
- Blades: 12
- Diameter: 3-3/4 in
- Width: 2-1/2 in
- Hub and Drive: 1 in spline drive, brass insert
- Packaging: Carton of 24 impeller kits
- Fits: Jabsco 6400 and 7420 series engine cooling pumps and the 17810-1000 engine cooling pump
- Quantity Needed: One per pump
- Condition: New
Frequently Asked Questions
Q: Should I grease the new impeller?
Yes, a light coat of water pump grease on the blades and hub helps it survive the first dry seconds before liquid arrives.
Q: Can I change impeller compound?
Yes, where the same impeller is offered in another compound for your pump. Choose the compound for the liquid being pumped.
Q: Why is my new impeller hard to fit?
The blades need to fold the right way. A little grease on the blades and turning the shaft in the running direction as you push helps.
Q: Which way should the blades bend?
They bend back against the direction of rotation as the impeller is pushed into the body. Turning the shaft in the running direction while pushing makes this easy.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct impeller.
CLRMarine
