Jabsco 16435-0000 Motor Cord Strain Relief
The Jabsco 16435-0000 is the genuine strain relief for the Jabsco drum pump electric motor, the fitting that grips the power cord where it enters the motor so the cord is not pulled on its terminals. Jabsco 16400 series drum pumps are portable, sealless centrifugal pumps that drop straight into a drum, carboy or vat, with a motor that clamps onto the top of the pump tube. Tubes come in polypropylene, stainless steel, sanitary and PVDF versions in 27, 35-1/2, 40 and 47 in lengths, driven by either an electric motor or an air motor.
Drum pump parts are replaced when a tube is cracked or bent, a shaft is worn or bent, or a motor or fitting has been damaged in handling. Always match the tube length and material to your pump, because the shaft, inner tubes and outer tube are made in matched lengths and materials for each tube model. Flush the pump with clean water or a compatible solvent after use, especially with corrosive liquids, and never run it dry for long periods.
Key Features
- Genuine Jabsco drum pump part
- For Jabsco 16400 series drum pumps
- Factory materials and dimensions
- Direct replacement for a worn or damaged part
- Keeps a drum pump in service
Applications
- Emptying drums, carboys and vats
- Chemical and corrosive liquid transfer
- Industrial and laboratory use
- Food and beverage transfer (sanitary tubes)
- Maintenance shops and plants
- Drum pump rebuilds
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 16435-0000
- Part Type: Cord strain relief
- Fits: Jabsco 16400 series drum pumps
- Condition: New
Frequently Asked Questions
Q: How do I know which tube length I have?
Measure the tube from the motor mount to the foot, or check the model number on the tube. Common lengths are 27, 35-1/2, 40 and 47 in.
Q: Can the drum pump run dry?
It should not be run dry for long. The pumped liquid cools and lubricates the internal parts.
Q: How should I clean the pump after use?
Run clean water or a compatible solvent through it, then let it drain, especially after corrosive liquids.
Q: Can I use an electric motor with flammable liquids?
Only a motor rated for that duty, with the drum and pump properly grounded. An air motor is the usual choice for flammable liquids.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct motor cord strain relief.
CLRMarine
