Jabsco 1414-0001-P Neoprene Impeller Kit
The Jabsco 1414-0001-P is a genuine Jabsco flexible impeller kit with a neoprene impeller. As it turns inside the offset pump body, the blades bend and straighten, drawing liquid in and pushing it out, which is what makes a flexible impeller pump self-priming. It is listed for the Jabsco 12210-0001 Handi-Puppy utility pump.
Neoprene is the general purpose compound for water, raw water cooling and mildly abrasive liquids. Impellers are wear parts. Replace one when blades are cracked, torn or have taken a permanent set in the curved position, when the pump is slow to prime, or after it has run dry even briefly. Lubricate the new impeller with a little water pump grease before fitting it, and fit a new end cover gasket or O-ring at the same time.
Key Features
- Genuine Jabsco replacement impeller
- Neoprene impeller compound
- Factory blade profile
- Correct fit for the matching pump
- Listed for 12210-0001 pumps
- Kit packed for service
Applications
- Jabsco 12210-0001 pumps
- Raw water and general water transfer
- Scheduled impeller replacement
- Recovery after the pump has run dry
- Marine and industrial pumps
- Keeping a spare aboard or in the shop
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 1414-0001-P
- Part Type: Flexible impeller kit
- Impeller Compound: Neoprene
- Fits: Jabsco 12210-0001 Handi-Puppy utility pump
- Quantity Needed: One per pump
- Condition: New
Frequently Asked Questions
Q: What causes blades to break off?
Running dry is the main cause. Broken pieces can travel downstream and block coolers or strainers, so find every piece.
Q: Should I grease the new impeller?
Yes, a light coat of water pump grease on the blades and hub helps it survive the first dry seconds before liquid arrives.
Q: Can I change impeller compound?
Yes, where the same impeller is offered in another compound for your pump. Choose the compound for the liquid being pumped.
Q: Why is my new impeller hard to fit?
The blades need to fold the right way. A little grease on the blades and turning the shaft in the running direction as you push helps.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct impeller.
CLRMarine
