Jabsco 12927-0000 End Cover Clamp
The Jabsco 12927-0000 is the genuine end cover clamp for Jabsco Pureflo 15070 and 15270 series sanitary pumps and 15170 series bulkhead mounted pedestal pumps. Pureflo pumps are the Jabsco 316 stainless steel sanitary flexible impeller pumps used on dairy, food, beverage, cosmetic and pharmaceutical products, built so the pump end can be opened quickly for cleaning. On these pumps the stainless steel end cover is held on by this clamp rather than screws, so the pump end can be opened by hand for cleaning and closed again quickly with a positive seal on its O-ring.
Because the clamp is opened at every cleaning, it sees far more cycles than an ordinary fastener. A clamp that is bent, cracked or worn at its hinge or screw no longer pulls the cover evenly onto the O-ring, which can cause leaks on the discharge side or let air in on the suction side. Replace the clamp at the first sign of distortion, and tighten it by hand only.
Key Features
- Genuine Jabsco end cover clamp
- For Pureflo stainless steel sanitary pumps
- Hand tightened for quick opening
- Pulls the cover evenly onto its O-ring
- Listed for Pureflo 15070, 15170 and 15270 series pumps
- Direct replacement for a bent or worn clamp
Applications
- Jabsco Pureflo 15070, 15170 and 15270 series pumps
- Dairy and food processing
- Beverage, brewing and winery transfer
- Cosmetic and pharmaceutical products
- Daily cleaning and teardown routines
- Spares for sanitary production lines
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 12927-0000
- Part Type: End cover clamp
- Fits: Jabsco Pureflo 15070 and 15270 series sanitary pumps and 15170 series bulkhead mounted pedestal pumps
- Quantity Needed: One per pump
- Condition: New
Frequently Asked Questions
Q: Is the clamp screw included?
The clamp screw is a separate part number. Check it at the same time, since it wears with every opening.
Q: Why does my pump leak at the end cover?
Check the O-ring first, then the clamp and its screw. A distorted clamp cannot pull the cover evenly.
Q: Is the same clamp used on every Pureflo size?
No. Clamps differ by pump series, so match the part number to the series on your pump plate.
Q: How tight should the clamp be?
Hand tight. The Pureflo clamp is designed for hand tightening, and using tools can distort the cover or cut the O-ring.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct clamp.
CLRMarine
