Jabsco 1210-0001-24 Neoprene Impellers, Carton of 24
The Jabsco 1210-0001-24 is a genuine Jabsco bulk carton of flexible impellers with a neoprene impeller, supplied as a carton of 24 impellers. As it turns inside the offset pump body, the blades bend and straighten, drawing liquid in and pushing it out, which is what makes a flexible impeller pump self-priming. It is listed for Jabsco 1673 series bronze pedestal pumps, 5850-0001 engine cooling pump and 18830 and 18840 series engine cooling pumps. The impeller itself is Jabsco 1210-0001.
Neoprene is the general purpose compound for water, raw water cooling and mildly abrasive liquids. Impellers are wear parts. Replace one when blades are cracked, torn or have taken a permanent set in the curved position, when the pump is slow to prime, or after it has run dry even briefly. Lubricate the new impeller with a little water pump grease before fitting it, and fit a new end cover gasket or O-ring at the same time. The carton of 24 suits fleets, service shops and anyone maintaining several pumps of the same model.
Key Features
- Genuine Jabsco replacement impeller
- Neoprene impeller compound
- Factory blade profile
- Correct fit for the matching pump
- Listed for 1673, 5850 and 18830 series pumps
- Carton of 24 impellers
Applications
- Jabsco 1673, 5850 and 18830 series pumps
- Raw water and general water transfer
- Scheduled impeller replacement
- Recovery after the pump has run dry
- Marine and industrial pumps
- Keeping a spare aboard or in the shop
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 1210-0001-24
- Part Type: Flexible impeller
- Impeller Compound: Neoprene
- Packaging: Carton of 24 impellers
- Fits: Jabsco 1673 series bronze pedestal pumps, 5850-0001 engine cooling pump and 18830 and 18840 series engine cooling pumps
- Quantity Needed: One per pump
- Condition: New
Frequently Asked Questions
Q: What causes blades to break off?
Running dry is the main cause. Broken pieces can travel downstream and block coolers or strainers, so find every piece.
Q: Should I grease the new impeller?
Yes, a light coat of water pump grease on the blades and hub helps it survive the first dry seconds before liquid arrives.
Q: Can I change impeller compound?
Yes, where the same impeller is offered in another compound for your pump. Choose the compound for the liquid being pumped.
Q: Why is my new impeller hard to fit?
The blades need to fold the right way. A little grease on the blades and turning the shaft in the running direction as you push helps.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct impeller.
CLRMarine
