Jabsco 11830-0000 End Cover
The Jabsco 11830-0000 is a genuine replacement end cover for Jabsco flexible impeller pumps. The end cover closes the front of the pump body over the impeller, and its inside face forms one wall of the pumping chamber, so a flat, true surface is what keeps each vane sealed as it sweeps past. It is listed for Jabsco 11810 series bronze utility pumps, the 5850-0001 engine cooling pump and 2620-1101 and 2620-1103 pedestal pumps.
Over thousands of hours the impeller vanes polish a groove into the inside face of the cover. Once that groove forms, liquid slips back past the vanes, output falls and the pump struggles to prime. Covers also crack when a pump is left full of water in freezing weather. Fit a new cover with a new gasket, and change the impeller at the same time if its vanes are worn or set.
Key Features
- Genuine Jabsco replacement end cover
- Machined flat sealing face
- Held by end cover screws
- Sealed with the matching end cover gasket
- Restores output and self-priming
- Listed for 11810, 5850 and 2620 series pumps
Applications
- Jabsco 11810, 5850 and 2620 series pumps
- Marine raw water and engine cooling service
- Utility, transfer and washdown pumps
- Replacing a grooved or cracked cover
- Pump rebuilds with a new impeller
- Marine and industrial installations
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 11830-0000
- Part Type: End cover
- Fits: Jabsco 11810 series bronze utility pumps, the 5850-0001 engine cooling pump and 2620-1101 and 2620-1103 pedestal pumps
- Quantity Needed: One per pump
- Condition: New
Frequently Asked Questions
Q: Should I change the impeller at the same time?
If the vanes are cracked, worn or have taken a set, yes. A new cover with a tired impeller will not restore full output.
Q: Can a scored end cover be turned over?
Some older covers were flat both sides, but most have locating features on one face only. A new cover is the reliable fix for a grooved face.
Q: Do I need a new gasket?
Always. The old gasket is compressed to the old cover, and its thickness helps set the internal clearance, so reuse invites leaks and air.
Q: Why did my cover crack?
Most often water froze inside the pump. Drain the pump by loosening the end cover whenever it will see freezing temperatures.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct end cover.
CLRMarine
