Jabsco 1133-0001 Impeller Kit, Neoprene
The Jabsco 1133-0001 is a genuine Jabsco flexible impeller kit with a neoprene impeller. The impeller has six blades, a 2 in diameter and a 7/8 in width, with a brass insert for a 1/2 in shaft driven by a pin in a slotted shaft. As it turns inside the offset pump body, the blades bend and straighten, drawing liquid in and pushing it out, which is what lets a flexible impeller pump self-prime. Jabsco uses this part number on specific pump models only, so match it against the parts list for the model number on your pump plate before ordering.
Neoprene is the general purpose compound for water, raw water cooling and mildly abrasive liquids. Impellers are wear parts. Replace one when blades are cracked, torn or have taken a permanent set in the curved position, when the pump is slow to prime, or after the pump has run dry, even briefly. Lubricate the new impeller with a little water pump grease before fitting it, and fit a new end cover gasket at the same time.
Key Features
- Genuine Jabsco impeller kit
- Neoprene impeller compound
- Six blade design
- 2 in diameter by 7/8 in wide
- 1/2 in shaft, brass insert with pin drive
- Restores flow and self-priming
Applications
- Jabsco flexible impeller pumps with this impeller size
- Raw water and general water transfer
- Scheduled impeller replacement
- Recovery after the pump has run dry
- Marine and industrial utility pumps
- Keeping a spare aboard or in the shop
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 1133-0001
- Part Type: Flexible impeller kit
- Impeller Compound: Neoprene
- Blades: 6
- Diameter: 2 in
- Width: 7/8 in
- Shaft: 1/2 in, pin drive
- Hub: Brass insert
- Fits: Specific Jabsco pump models, confirm against your pump plate
- Quantity Needed: One per pump
- Condition: New
Frequently Asked Questions
Q: How long does an impeller last?
It depends on hours, temperature and what is being pumped. Many owners replace it every season or at a set number of running hours as insurance.
Q: What causes blades to break off?
Running dry is the main cause. Broken pieces can travel downstream and block coolers or strainers, so find every piece.
Q: Should I grease the new impeller?
Yes, a light coat of water pump grease on the blades and hub helps it survive the first dry seconds before liquid arrives.
Q: Neoprene or nitrile?
Neoprene for water service, nitrile where oils or fuels are present. Use the compound listed for your pump application.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct impeller kit.
CLRMarine
