Jabsco 10408-0010 Clamp Screw
The Jabsco 10408-0010 is the genuine end cover clamp screw for Jabsco Pureflo 15010 and 15210 series sanitary pumps. Pureflo pumps are the Jabsco 316 stainless steel sanitary flexible impeller pumps used on dairy, food, beverage, cosmetic and pharmaceutical products, built so the pump end can be opened quickly for cleaning. On these pumps the stainless steel end cover is held on by a clamp rather than screws, and this clamp screw draws the clamp tight so the cover seals against its O-ring and can be released again by hand for cleaning.
Because the clamp is opened at every cleaning, the clamp screw sees far more cycles than an ordinary fastener, and the thread and tip wear with use. A worn or bent screw will not hold the clamp evenly, which lets the cover rock on its O-ring and can cause leaks or air ingress on the suction side. The clamp is designed to be hand tightened, so replace the screw rather than forcing a worn one with tools.
Key Features
- Genuine Jabsco clamp screw
- For Pureflo stainless steel sanitary pumps
- Tightens the end cover clamp by hand
- Allows quick opening for cleaning
- Listed for Pureflo 15010 and 15210 series pumps
- Direct replacement for a worn or bent screw
Applications
- Jabsco Pureflo 15010 and 15210 series pumps
- Dairy and food processing
- Beverage, brewing and winery transfer
- Cosmetic and pharmaceutical products
- Daily clean in place and teardown routines
- Spares for sanitary production lines
Specifications
- Brand: Jabsco
- Manufacturer Part Number: 10408-0010
- Part Type: End cover clamp screw
- Fits: Jabsco Pureflo 15010 and 15210 series sanitary pumps
- Quantity Needed: One per pump
- Condition: New
Frequently Asked Questions
Q: How tight should the clamp be?
Hand tight. The Pureflo clamp is designed for hand tightening, and using tools can distort the end cover or cut the O-ring.
Q: Why does my pump leak at the end cover?
Check the O-ring first, then the clamp screw and clamp. A worn screw cannot pull the clamp evenly around the cover.
Q: Does the clamp come with the screw?
No. This part number is the clamp screw only. The clamp itself is a separate part.
Q: Is the same screw used on every Pureflo size?
No. Clamp screws differ by pump series, so match the part number to the series on your pump plate.
Not sure this is the right part? Send us a Picture of the Pump Plate on your pump and the CLR Marine team will confirm the correct clamp screw.
CLRMarine
