Finish Thompson PFP-27 PF Polypropylene Drum Pump 27 Inch
This is the Finish Thompson PF drum pump in the 27 inch tube length, constructed in polypropylene. It is supplied as the pump tube and is driven by a matched Finish Thompson motor. The tube is polypropylene throughout the wetted path, which covers most acids, caustics and plating chemistry, and the pump is sealless so nothing has to hold pressure against a rotating shaft.
A drum pump earns its keep by removing the tip and pour from the job. These are sealless tube pumps, so there is no shaft seal to weep down the outside of the drum, and the bearings are lubricated by the fluid itself rather than by grease. That makes flushing after use the single most useful habit, because a pump left full of product is a pump that seizes.
Key Features
- Polypropylene wetted construction for acids and caustics
- Sealless tube design with no shaft seal to leak
- Fluid lubricated bearings along the length of the tube
- Accepts a bung adapter to stand upright in the container
- Matched to Finish Thompson drum pump motors
Applications
- Emptying drums, totes and carboys of process chemicals
- Acid, caustic and plating chemical dispensing
- Water treatment and laboratory chemical handling
- Decanting into smaller containers under control
- Replacing tipping and pouring of heavy containers
Specifications
- Brand: Finish Thompson
- Model: PFP-27
- Series: PF
- Type: Drum and container pump
- Wetted Material: Polypropylene
- Tube Length: 27 inch
- Condition: New
Frequently Asked Questions
Q: Can the pump be left standing in the drum between uses?
Only if the wetted materials suit the fluid for long contact. Otherwise it should be flushed and drained, since standing exposure is harder on a pump than pumping is.
Q: What happens if the pump is run dry?
The bearings are lubricated by the fluid being pumped, so dry running wears them quickly and can seize the shaft.
Q: Does the pump need a bung adapter?
It does if the container is to hold the pump upright, and the adapter also limits fumes escaping around the tube.
Q: How should the pump be flushed?
With a fluid compatible with both the product and the pump materials, run long enough to clear the full length of the tube.
Not sure this is the right part? Send us a Picture of the pump plate on your pump and the CLR Marine team will confirm the correct drum pump before you order.
CLRMarine
