Finish Thompson KC6HPCVN385C KC6H Magnetic Drive Pump end
Finish Thompson builds the KC6HPCVN385C as a KC6H sealless magnetic drive pump end in glass fiber reinforced polypropylene. It is supplied as the pump end, ready to mount on a motor of the matching frame. There is no mechanical shaft seal anywhere in the design: the motor turns an outer magnet, and the field couples through a solid containment barrier to the magnet inside the impeller, so the only way out for the pumped fluid is the discharge port.
Removing the seal removes the usual failure mode. On a conventional pump the seal is what weeps, what needs flushing and what puts the pump back on the bench, and none of that applies here. The wetted parts are glass fiber reinforced polypropylene with a carbon bushing and a ceramic shaft, and the elastomers are Viton FKM. The unit is built for a NEMA 56C motor frame. Maximum working pressure for this size is 60 psi, with the housing material setting the temperature ceiling at 180 degrees F.
Key Features
- Sealless magnetic drive with no shaft seal and no leak path
- Glass fiber reinforced polypropylene wetted construction
- Carbon bushing on a ceramic shaft
- Neodymium magnets for full torque in a compact coupling
- Back pull out design so the wet end is serviced without disturbing the piping
Applications
- Acid, caustic and solvent transfer where a leak cannot be tolerated
- Plating, etching, anodizing and metal finishing lines
- Water treatment, scrubber and filtration recirculation
- Laboratory, photo processing and chemical blending systems
- Replacing a sealed pump that keeps failing at the shaft seal
Specifications
- Brand: Finish Thompson
- Model: KC6HPCVN385C
- Series: KC6H
- Type: Sealless magnetic drive centrifugal pump end
- Wetted Material: Glass fiber reinforced polypropylene
- Bushing: Carbon
- Shaft: Ceramic
- Elastomers: Viton FKM
- Maximum Working Pressure: 60 psi
- Maximum Temperature: 180 degrees F
- Motor Frame: 56C
- Impeller Diameter: 3.88 inch
- Connections: NPT threaded
- Condition: New
Frequently Asked Questions
Q: Can the bushing material be changed later?
Yes, and it often is. Carbon suits most duties and tolerates brief dry running, while PTFE and ceramic are chosen where the chemistry attacks carbon.
Q: What happens during a magnet decoupling?
The two magnet sets slip out of step, the pump stops delivering and heat builds quickly, which is why a decoupled pump should be stopped rather than left running.
Q: Does the elastomer choice limit the pump?
It often limits it more than the housing does, since a Viton ring fails on caustics and hot water where an EPDM ring would last.
Q: Is a suction strainer worth fitting?
On a magnetic drive pump, yes. The running clearances are small and a single piece of debris can take out the bushing.
Not sure this is the right part? Send us a Picture of the pump plate on your pump and the CLR Marine team will confirm the correct pump end before you order.
CLRMarine
