Finish Thompson J101031 Ceramic Seat
This is the Finish Thompson Finish Thompson drum pump, constructed in null. The J101031 is a Finish Thompson ceramic seat, the stationary face that a mechanical seal runs against.
A drum pump earns its keep by removing the tip and pour from the job. Because the exact model fitment for this part number is not published in the Finish Thompson service literature, check it against your own pump parts list or send us the pump plate details before ordering and we will confirm it for you.
Key Features
- Stationary ceramic face for a mechanical seal
- Hard wearing surface for the rotating carbon face
- Factory part built to the original specification
- Renewed together with the rotating seal face
- Supplied as a single component
Applications
- Mechanical seal replacement on a sealed pump
- Repair of a pump weeping at the shaft
- Planned seal service intervals
- Rebuild after a dry running incident
- Restoring a pump to its original seal arrangement
Specifications
- Brand: Finish Thompson
- Manufacturer Part Number: J101031
- Part Type: Ceramic Seat
- Condition: New
Frequently Asked Questions
Q: Can the pump be run briefly without this part?
No. Every component in the wet end carries a load or seals a joint, and running incomplete risks far costlier damage.
Q: Is this the genuine manufacturer part?
Yes. It is the factory component built to the original specification rather than a pattern copy.
Q: Should anything else be replaced at the same time?
Whatever the teardown exposes. Elastomers and bushings are inexpensive and are best renewed while the pump is already apart.
Q: What causes most premature failures on this part?
Running the pump outside what it was specified for, whether that is temperature, viscosity, dry running or an incompatible chemical.
Not sure this is the right part? Send us a Picture of the pump plate on your pump and the CLR Marine team will confirm the correct ceramic seat before you order.
CLRMarine
