Finish Thompson A100002-2 PVDF Impeller Assembly
This is the factory pvdf impeller assembly for Finish Thompson PFM, PFP and PFV sealless drum pumps. It is the rotating element at the bottom of the pump tube that does the actual pumping work. It is built in PVDF, which is what decides where it can safely be used.
It is one of the parts worth renewing on schedule instead of waiting for a fault. An impeller that has been run dry, run against a closed discharge, or fed abrasive product loses its edges and the pump gradually stops making the flow it used to. Check the pump build before ordering, because these pumps are offered in more than one material and size combination and the alternatives look similar on the shelf.
Key Features
- PVDF Impeller Assembly in PVDF built to the original factory specification
- PVDF construction for broad chemical resistance
- Common impeller across the PFM, PFP and PFV drum pump models
- Sized and finished to drop straight into the position it came from
- Inexpensive component whose failure takes the whole pump out of service
Applications
- Finish Thompson PFM, PFP and PFV sealless drum pumps
- Acid and solvent drum and tote emptying
- Restoring lost flow on a drum pump that has slowed
- Scheduled overhaul and annual inspection of the pump
- Repair of a pump taken out of service after a leak or a loss of performance
Specifications
- Brand: Finish Thompson
- Manufacturer Part Number: A100002-2
- Part Type: PVDF Impeller Assembly
- Material: PVDF
- Position: Impeller housing at the foot of the pump tube
- Fits: Finish Thompson PFM, PFP and PFV sealless drum pumps
- Quantity Per Pump: 1
- Condition: New
Frequently Asked Questions
Q: Is this the genuine manufacturer part?
Yes. It is the factory component built to the original specification rather than a pattern copy.
Q: Should anything else be replaced at the same time?
Whatever the teardown exposes. Elastomers and bushings are inexpensive and are best renewed while the pump is already apart.
Q: What causes most premature failures on this part?
Running the pump outside what it was specified for, whether that is temperature, viscosity, dry running or an incompatible chemical.
Q: Does fitting this affect the pump warranty?
Using the factory part keeps the pump to its original specification, which is what any warranty position depends on.
Not sure this is the right part? Send us a Picture of the pump plate on your pump and the CLR Marine team will confirm the correct impeller assembly before you order.
CLRMarine
